Re: [Elecraft] Transverter calibration

Alan, I have the same issue; mine is off about 50Hz. Not a huge deal but just enough to be annoying on VHF SSB and CW. I do have the REFLOCK, EXTREF (10MHz GPSDO) and KTCXO-1; nothing left to add. You are correct that you can’t adjust the offset once you’re in this configuration. As I say,

Re: [Elecraft] Microphone in 12 Watts

German, Use the power control to the right of it. That is, once you have set up the gain, AGC, etc. for the mic. It is in the manual, but if you don't have a copy, download from Elecraft site. 73, Bill K9YEQ https://wrj-tech.com/ -Original Message- From:

[Elecraft] Microphone in 12 Watts

Dear friends: When I did resetting of my Elecraft K3s, the microphone is fixed at 12 W. How do I make the microphone increase the power? Thank you. Germán HK3J __ Elecraft mailing list Home:

[Elecraft] OT: FS: LNR Precision MTR5B

The MTR5b has been sold. 73, Jim, W0EB __ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by:

[Elecraft] OT: FS LNR Precision MTR5B Mountaintopper

At age 76, I don't get out to portable locations any more and this is totally surplus to my needs. I bought this MTR5B "MountainTopper" new from LNR Precision ($400) a couple years ago. Used it when I went to visit my sisters & neices in Florida and Louisiana with excellent results. I did

Re: [Elecraft] Transverter calibration

Alan Does your k3 have the KTCXO3-1 upgraded reference oscillator or the original KREF3 oscillator? The KTCXO3-1 is recommended by Elecraft when locking I had a similar issue to you on my 1st K144XV installation locking it with the KREF3, as it was outside the range of the software offset

Re: [Elecraft] KPA-1500 ATU not working well

I'm not clear whether you are talking about the SWR before or after the tuner, but efficiency is determined by the load seen by the PA, which has two degrees of freedom (reactance and resistance), both of which can vary either side of the ideal. SWR reduces this to a single variable, that

Re: [Elecraft] [K3] Add to NTCH and APF

write a macro?? Bill W2BLC K-Line __ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net

Re: [Elecraft] [K3] Add to NTCH and APF

Hi Petr, Have you tried Save and then Restore Config in the K3 Utility? I know this is somewhat inconvenient but it might work (don't know if it will but worth a try). 73, Bill W4ZV -- Sent from: http://elecraft.365791.n2.nabble.com/