Hi Roy and all
I own a HL-550FX. At the time I bought it for DXpeditions the KPA-500 had
not been released yet.
Just to make the comparison fair, it does not take 5 minutes do reset
after an alarm. You will need to turn it on/off and it will go to normal
state again.
Regarding the input power
Is there any documentation on ATU which explains how it stores antenna
matching parameters in its memory, if it ever does ?
It seems to me that after actioning on the ATU and getting a good match on
a given frequency, when I get back to it again, after tuning on some other
bands, using the same
Hi Guys, Happy new year to everyone.
In order to use the KX3 with an external amplifier in QSK mode, I need to
check how long it takes for the KX3 to transmit after Keyline goes low.
Is this delay configurable by menu ?
If it does not delay enough I will probably need to use TX INHIBIT line to
when the fault
exists. It would also be the best time to check whether the LO's output is
reaching the mixers if the LO is working.
73,
Geoff
LX2AO
On August 27, 2012 4:04 PM, Fred Carvalho wrote:
snip
However during my tests, the reception went back on for a while. It does
this !!! I
should hear it at good strength on your main receiver. By placing the
Sniffer close to each of the mixers, you should also be able to tell if
the LO signal is reaching the mixers or not.
Good luck!
73,
Geoff
LX2AO
On August 27, 2012 at 12:50 AM, Fred Carvalho wrote:
snip
Hello guys
Need some help to start with.
I have a KX3 purchased in May. It has the roofing filter and the ATU unit.
I have not updated the firmware yet. Still with the one loaded in the
factory.
Recently the radio went mute. Also when trying to match the antenna with
the ATU, SWR displayed 25:1.
check this, didn't
you?
...bc nr4c
-Original Message-
From: Fred Carvalho [mailto:fred.py...@gmail.com]
Sent: Sunday, August 26, 2012 5:31 PM
To: elecraft@mailman.qth.net
Subject: [Elecraft] KX3: No RX - SWR 25 to 1
Hello guys
Need some help to start with.
I have a KX3
any action on S-meter?
** **
Is speaker plugged in to main board?
** **
...bc nr4c
** **
--
*From:* Fred Carvalho [mailto:fred.py...@gmail.com]
*Sent:* Sunday, August 26, 2012 6:14 PM
*To:* Bill Conkling
*Cc:* elecraft@mailman.qth.net
connector is plugged into the
ATU.
It sounds like the antenna is not connected, you did check this, didn't
you?
...bc nr4c
-Original Message-
From: Fred Carvalho [mailto:fred.py...@gmail.com]
Sent: Sunday, August 26, 2012 5:31 PM
To: elecraft@mailman.qth.net
Subject: [Elecraft
Guys, I have flown with different radios internally and internationally
including USA. I carry radios and main accessories in a kind o pelican
briefcase. In the briefcase I have the radio, power supply, electronic
keyer, digi interface, cables and so on. I have never had a problem.
I have also
Hi guys.
Have anyone used the KX3 beta units ? Does someone have inputs of actual
impressions of the rig ? What are your general expectation about this radio?
Thanks for your time
--
Fred C Carvalho - PY2XB
__
Elecraft mailing list
11 matches
Mail list logo
