Sam, follow this link:
http://www.qth.com/topten/bdecoder.htm
Lou, W0FK
Sam,
The Top Ten Devices Yaesu decoders that you already own will work
perfectly with the K3. All you need is a new radio interface cable.
-
St. Louis, MO
K3 #2513
--
View this message in context:
http://n2.na
t;
> Message: 39
> Date: Tue, 8 Apr 2008 16:04:08 -0700 (PDT)
> From: "J. Heide" <[EMAIL PROTECTED]>
> Subject: [Elecraft] K3 - Band Decoder
> To: Elecraft@mailman.qth.net
> Message-ID: <[EMAIL PROTECTED]>
> Content-Type: text/plain; charset=us-ascii
>
h.net; [EMAIL PROTECTED]
Subject: [Elecraft] K3 Band Decoder
Buy a Phidget 16/16 board ($100), write a little Visual Basic 6 code,
input the K3's band data to the Phidget Board, and "bingo", out comes
whatever switching logic you need on any or all of the 16
outputs!(slightly over
Apr 2008 16:04:08 -0700 (PDT)
From: "J. Heide" <[EMAIL PROTECTED]>
Subject: [Elecraft] K3 - Band Decoder
To: Elecraft@mailman.qth.net
Message-ID: <[EMAIL PROTECTED]>
Content-Type: text/plain; charset=us-ascii
OK, now that the Katiegram has arrived, I need to think about an
Josh,
Since you already have the KRC2 set up to switch your antennas, I would
suggest you use that with the K3. Connect the K3 ACC pin 2 (AUXBUS)
signal to KRC2 pin 6, connect the K3 Keyout signal (ACC pin 10) to KRC2
pin 9, and Ground (ACC pin 5 or 12) to KRC2 pin 1.
The KRC2 needs 12 volt p
AIL PROTECTED]>
To:
Sent: Tuesday, April 08, 2008 4:04 PM
Subject: [Elecraft] K3 - Band Decoder
>
> OK, now that the Katiegram has arrived, I need to think about
antenna switching. I have the following antennas that I want to use
with the K3
> Windom for most all bands
> Yagi for 2
OK, now that the Katiegram has arrived, I need to think about antenna
switching. I have the following antennas that I want to use with the K3
Windom for most all bands
Yagi for 20 meters
Yagi for 6 meters (goes to the XV50)
Vertical for 160 meters
Vertical for 6m FM (which is not used with the K2
7 matches
Mail list logo