Hi,
On 80 meters I did some tuning and when I try the SWR about 12 KHz lower the
tuner produces an extra click and the SWR is terrible again. It seems the tuner
remembers segments of about 20 KHz.
Is it possible to keep the tuner in its tuned settings so it is not necessary
to tune the
If the feedline antenna combination is such that a 1.5:1 segment is
only 20 kHz wide (a common enough occurrence) then one should take the
time to get tunings up and down. You can probably do it in a couple
of minutes. The K3 will shift seamlessly with your operating after
that. One of the
] KAT3 tuning bandwidth
If the feedline antenna combination is such that a 1.5:1 segment is
only 20 kHz wide (a common enough occurrence) then one should take the
time to get tunings up and down. You can probably do it in a couple
of minutes. The K3 will shift seamlessly with your
That would be a great advantage.
David
G3UNA
A new feature would then be to reset the old KAT3 settings or to 'calibrate'
the whole band automatically with the KAT3. And after that it is a little
step to a complete antenna analyzer feature on the K3 hi!
73 's Steef PA2A
@mailman.qth.net
Subject: Re: [Elecraft] KAT3 tuning bandwidth
That would be a great advantage.
David
G3UNA
A new feature would then be to reset the old KAT3 settings or to 'calibrate'
the whole band automatically with the KAT3. And after that it is a little
step to a complete antenna analyzer
: [Elecraft] KAT3 tuning bandwidth
See page 56 in the user manual. Put the K3 on the band you want to
clear. Go to CONFIG:KAT3:LC SET. Tap CLR. This should clear the
memories for that band.
73, Guy.
__
Elecraft mailing list
Home: http
remained in the same position because no
relay clicks were audible when turning the VFO across the band.
73 's Steef PA2A
- Original Message -
From: Guy Olinger K2AV
To: Steef PA2A
Sent: Sunday, August 01, 2010 11:35 PM
Subject: Re: [Elecraft] KAT3 tuning bandwidth
See
7 matches
Mail list logo