It sounds like I have the same problem as Jack, and I upgraded from 2.82.
The noise floor appears to rise with the signals and there is a crackle
generated by the speech peaks. It all sounds quite strange.
Stephen G4SJP K3#980
On 18/03/2009 01:00, list1 li...@pituch.net wrote:
Hi Wayne
After the dust settles it would be nice to get a general idea of
preferred settings for contest conditions AGC settings.
Thank you,
73
Jack, W3TMZ
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help:
Hi Jack,
I'm presently using all the defaults, plus AGC HLD = 0.3 (slow AGC hold
time in seconds) and AGC DCY = Soft (soft-decay characteristic for both
fast and slow AGC). The AGC HLD and AGC DCY settings should prove very
useful during pileups, although some ops may prefer to leave them off.
Hi Wayne and all,
Just before our MARS net tonight I installed Beta 3.03.
When the net started I had a lot of distortion on all the signals regardless
of signal strength. It sounded like the static went up as stations spoke.
I did not know what was changed so I reloaded FW 2.78 complete (during
Steve,
I suspect you had one or two EEPROM locations that were not set
correctly after the upgrade. There may have been an incompatibility
between 2.78 and 3.03 that I didn't catch.
If this happens to anyone else when they go to 3.03, I'll dig into it
further.
BTW, the suggested value for
[mailto:elecraft-boun...@mailman.qth.net]on Behalf Of list1
Sent: Tuesday, March 17, 2009 8:00 PM
To: elecraft@mailman.qth.net
Subject: Re: [Elecraft] Suggested AGC settings for Beta 3.03
Hi Wayne and all,
Just before our MARS net tonight I installed Beta 3.03.
When the net started I had a lot of distortion
Hi All,
On another net now.
OK, using AGC HLD = .3 and AGC DCY = SOFT.
Quality sounds good.
With Version 2.78 AGC HLD defaulted to 0.0. That was my problem.
Steve, W2MY, AAR6CX
-Original Message-
From: wayne burdick [mailto:n...@elecraft.com]
Sent: Tuesday, March 17, 2009 8:10 PM
7 matches
Mail list logo
