Just got my K3 delivered and 2 small manila envelopes were included - an
Allen wrench and the above referenced cable. What is the cable for?
On another note, since it will be a few more weeks until I have some
antennas outside, I connected a rolled up dipole (indoors) to ANT1 just to
listen a
It sounds like you purchased a factory assembled K3 with the KRX3
Subreceiver and with the KRX3 auxiliary input connected to a BNC on the K3
rear panel. That TMP cable is provided for an alternate antenna input option
you can install that feeds the KRX3 auxiliary antenna input from the ANT1 or
Yes, the noise goes away when I disconnect the antenna. I only listened
on 20 and 40m. Will try some other freqs today...
Tnx,
Barry W2UP
Ron D'Eau Claire wrote:
It sounds like you purchased a factory assembled K3 with the KRX3
Subreceiver and with the KRX3 auxiliary input connected to a BNC
Hi Charles,
Since your KRX3 was factory installed, this is probably a spare. :-)
73, Eric WA6HHQ
Charles Harpole wrote:
With my radio from the factory, I got a
TMP cable 12 part #E850339.
What is it for and why should I get it?
___
Elecraft
[EMAIL PROTECTED]
Cc: elecraft@mailman.qth.net
Sent: Monday, September 22, 2008 5:51 PM
Subject: Re: [Elecraft] what is a TMP cable?
Hi Charles,
Since your KRX3 was factory installed, this is probably a spare. :-)
73, Eric WA6HHQ
Charles Harpole wrote:
With my radio from the factory, I got
With my radio from the factory, I got a
TMP cable 12 part #E850339.
What is it for and why should I get it?
Thanks. 73
Charles Harpole
[EMAIL PROTECTED]
___
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to
On Sun, Sep 21, 2008 at 9:13 AM, Charles Harpole [EMAIL PROTECTED] wrote:
TMP cable 12 part #E850339.
What is it for and why should I get it?
It is one of the cables used for the second receiver module, KRX3. If
you have the receiver module, you can start reading at page 22 of the
7 matches
Mail list logo