John asked me to post this additional useful info.
-- Enno
=
I wanted to report back to you on the noise I was encountering with my K3.
I was not aware of this but changing the RX EQ settings other than default
will cause excess noise when changing to the cw mode. When I cleared
When I listen on ANT1 and switching to ANT2 (not connected to anything)
I can hear pretty good signals on ANT1 on all bands! What is wrong?
regards,
E72X,
Jim Brown-10 wrote:
On Wed, 24 Sep 2008 07:59:36 -0400, Monty Shultes wrote:
I have very high white noise in my K3 on 75 meters
This is what N4DSP sent me as a reaction (he is not a mailing list
subscriber).
Like N4DSP and in addition to my initial posting, I have compared with my
1000MP, and although I can hear the same station on both rigs, listening
with the 1000MP is just more relaxing.
Enno -
I have very high white noise in my K3 on 75 meters when connected to the
serial port computer interface. Removing this connection greatly reduces the
noise. If you use HRD, LP-BRIDGE, or any control software, you can also
hear a pulsing noise related to polling the K3 over the serial
With the new firmware, I found it necessary to do the S-meter calibration.
This restored the previous base behavior.
Not sure what the state was before the calibration, whether I had done the
prior calibration correctly, etc., so I can't blame the firmware. My
guess, though, is that I'm on a
On Wed, 24 Sep 2008 07:59:36 -0400, Monty Shultes wrote:
I have very high white noise in my K3 on 75 meters when connected to the
serial port computer interface. Removing this connection greatly reduces the
noise. If you use HRD, LP-BRIDGE, or any control software, you can also
hear a pulsing
UART in the
USB device.
-Original Message-
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Jim Brown
Sent: Wednesday, September 24, 2008 12:45 PM
To: Elecraft List
Subject: Re: [Elecraft] AGC behaviour
On Wed, 24 Sep 2008 07:59:36 -0400, Monty Shultes wrote
7 matches
Mail list logo
