Well said.
Dave George
Unisys (sorry for the plug)
--
From: Rose, Manning I[SMTP:ros...@srdpost.daytonoh.ncr.com]
Sent: Thursday, February 12, 1998 9:34 AM
To: emc-p...@ieee.org; richard_c...@iris.scitex.com; Jim Hulbert
Subject: Upcoming EMC Seminar
EMC ENGINEER
The Document Company, Xerox presently has an opening in our
Corporate Strategic Services facility in El Segundo, CA., for a Sr. EMC
engineer.
You will ensure products meet regulatory requirements by providing
board and systems level design guidance, conducting simulations and
It was me that started the most recent thread on this. Here are all the
responses I received, in no particular order: (separated by *'s
). Of course, for European approval purposes, IEC73 has the final say,
but it is as open to interpretation as any standard. It is interesting
to note
Another source is Fair-rite Corporation in New York State (914.895.2055).
_
Kurt B. Fischer
International Compliance Corporation
802 N. Kealy
Lewisville, TX 75057-3136
Voice: 972.436.9600
Fax:972.436.2667
e-mail: kfisc...@icomply.com
web page:
Frankly, I like to have information on EMC and Safety matters. I do believe
that people have failed to recognize that there can be information on
seminars.
If they want the info supplied by an independent third party, sobeit. From
looking at the informational memos, I fail to see the blatant
To all,
I agree that limited amount of announcing publicity is no violation.
Keep it short however, and limit it to facts.
Want to supply more info: add a link or e-mail address.
==
CE-test, qualified testing,
Consultancy, Compliance tests for EMC and Electrical Safety
15 Great EMC-design
Hello Patrick and group,
Before considering any filtering just look at the problem. Theoretically what
you have is a switch, followed by a load. The switch is a differential switch.
So only RF-components should appear as a differential mode voltage between the
two supply lines. A simple
I second Max's presentation.
Bogdan.
bogdan.mat...@fibre.com
__ Reply Separator _
Subject: RE: Re[2]: Upcoming EMC Seminar
Author: Max Kelson mkel...@es.com at Internet
List-Post: emc-pstc@listserv.ieee.org
Date:
Eric,
I had a similar problem with a DeviceNet interface. Both sides are low
voltage and the spec says it should have a 500V isolation. I do not
consider this a safety spacing as such but my PCB designers needed some
guidance. I used the full 500V spacings but not from the Overvoltage
In article 199802051145_mc2-3210-5...@compuserve.com, Peter E.
Perkins peperk...@compuserve.com writes
Jim
I agree with you, you are responsible for the product - its design
and manufacturing (albiet thru a contract manufacturer) - so you will
develop your technical file (have your
10 matches
Mail list logo