oller (EMC)'
Datum: 7. 12. 2025 8:04:03
Předmět: Re: [Emc-users] Accessing python hal valriables.
"Thank you for your reply.
Imagine a piece of 1" round stock sitting upright in the vise. I use the
VERS.BY probe to find the center of it. Positioned approximately at centre
and about
if self.gcode(s) == -1:
return
If this failed it should never go down and touch the piece.
-Original Message-
From: Zdenek Z [mailto:[email protected]]
Sent: December 6, 2025 10:04 PM
To: Enhanced Machine Controller (EMC)
Subject: Re: [Emc-users] Accessing python hal v
is why it then goes downwards.
John
> -Original Message-
> From: Robert Schöftner [mailto:[email protected]]
> Sent: December 7, 2025 12:53 AM
> To: [email protected]
> Subject: Re: [Emc-users] Accessing python hal valriables.
>
> Am Samstag, dem 06.12.2025
Am Samstag, dem 06.12.2025 um 16:19 -0800 schrieb John Dammeyer:
> To add to this I can set the distance to 0.4" and then use the inner
> hole to find center. That works but again the distance is smaller.
> I've attached two small photos. Hopefully they come through.
> John
Does this behaviour c
signal on the HALscope while measuring or running
the machine.
Zdeněk
-- Původní e-mail --
Od: John Dammeyer
Komu: 'Enhanced Machine Controller (EMC)'
Datum: 7. 12. 2025 8:04:03
Předmět: Re: [Emc-users] Accessing python hal valriables.
"Thank you for your reply.
Ima
return
If this failed it should never go down and touch the piece.
> -Original Message-
> From: Zdenek Z [mailto:[email protected]]
> Sent: December 6, 2025 10:04 PM
> To: Enhanced Machine Controller (EMC)
> Subject: Re: [Emc-users] Accessing python hal valriables.
anced Machine Controller (EMC)'
Datum: 7. 12. 2025 1:22:39
Předmět: Re: [Emc-users] Accessing python hal valriables.
"To add to this I can set the distance to 0.4" and then use the inner hole
to find center. That works but again the distance is smaller.
I've attached two small ph
> -Original Message-
> From: Andy Pugh [mailto:[email protected]]
> Sent: December 6, 2025 1:35 PM
> To: Enhanced Machine Controller
> Cc: Enhanced Machine Controller
> Subject: Re: [Emc-users] Accessing python hal valriables.
>
>
>
> > On 6 Dec 2025,
> On 6 Dec 2025, at 19:31, John Dammeyer wrote:
>
> How do I access from workpiece_measurement.py the
> variable:
One way would be to create a HAL pin and set the value in that part of the
code.
But “print” might be enough if you start LinuxCNC from the command line.
__
Hi,
I'm seeing problems with the original version of psng for probing. I'm
using the files that were changed to imperial measurements and although
finding the center of a round part when it was less than 1" diameter worked
great it failed for something closer to 2" diameter.
After it probes the
10 matches
Mail list logo
