On 9/27/2013 7:38 AM, Marius Liebenberg wrote:
> Cheap yes until you loose a limb. There is no cost to high when it come
> to safety guy.
>
> What happens if you are busy with a cleaning or changing a tool and the
> pc falls over turning the spindle on. I have seen it happen.
Won't be falling over
PM, Peter C. Wallace wrote:
>> On Thu, 26 Sep 2013, Thomas Kaiser wrote:
>>
>>> Date: Thu, 26 Sep 2013 23:33:53 +0200
>>> From: Thomas Kaiser
>>> Reply-To: "Enhanced Machine Controller (EMC)"
>>>
>>> To: "Enhanced Mac
ler (EMC)"
>>>
>>> To: "Enhanced Machine Controller (EMC)"
>>> Subject: [Emc-users] Homebrew BOB
>>>
>>> Hello
>>>
>>> I read this page
>>> http://wiki.linuxcnc.org/cgi-bin/wiki.pl?About_Charge_Pumps.
>>
On 9/26/2013 4:48 PM, Peter C. Wallace wrote:
> On Thu, 26 Sep 2013, Thomas Kaiser wrote:
>
>> Date: Thu, 26 Sep 2013 23:33:53 +0200
>> From: Thomas Kaiser
>> Reply-To: "Enhanced Machine Controller (EMC)"
>>
>> To: "Enhanced Machine Cont
On Thu, 26 Sep 2013, Thomas Kaiser wrote:
> Date: Thu, 26 Sep 2013 23:33:53 +0200
> From: Thomas Kaiser
> Reply-To: "Enhanced Machine Controller (EMC)"
>
> To: "Enhanced Machine Controller (EMC)"
> Subject: [Emc-users] Homebrew BOB
>
> Hello
>
Hello
I read this page
http://wiki.linuxcnc.org/cgi-bin/wiki.pl?About_Charge_Pumps.
What is needed to make sure the BOB is only active when LinuxCNC is up,
running and healthy?
When LinuxCNC is not running, some outputs are in the wrong state.
Therefore, I would like to enable the BOB only wh
