On Saturday, December 31, 2011 11:57:46 PM dave did opine:
> Hm! Maybe half that ... 0.0525 center to center. :-)
>
And precisely the figure I used when I said to heck with this and wrote it
by hand. But I used a g3 for a climb cut, worked perfectly. Then I put an
engraving bit in, set it
Hm! Maybe half that ... 0.0525 center to center. :-)
dave
On Sat, 31 Dec 2011 00:55:20 -0500
gene heskett wrote:
> Greetings;
>
> Lots of editing to no avail, but I believe I have a clue to the
> G41-42 problem. The preset radius is for a .230" diameter circle,
> but if I use a .125 mill
On Saturday, December 31, 2011 03:38:48 PM Terry Christophersen did opine:
> Your New Years eve sounds as exciting as mine
ROTFL! But, I can remember 50 or 60 years back, doing New Years Eve up
right. But for the life of me, I can't remember why...
> I am running some small parts on my Hardin
Your New Years eve sounds as exciting as mine
I am running some small parts on my Hardinge--its
not so bad though 1 bar of material runs for a hour or so.
Dont have too much fun with the Jack
Have a safe and Happy New Year
Terry
Have a safe an
- Original Message -
From: gene heskett
To
On Saturday, December 31, 2011 01:48:48 PM Terry Christophersen did opine:
> .125dia tool cutting a .230dia ID will leave you .0525 move
> if you are starting in the center of the hole and moving to the edge
This is I believe the crux of the problem. This code generator does not
start at the
Sorry , ignore my reply I didnt read far enough
Sorry Everybody
Terry
- Original Message -
From: gene heskett
To: emc-users@lists.sourceforge.net
Cc:
Sent: Friday, December 30, 2011 11:55 PM
Subject: [Emc-users] Possible bug in G41-42 stuffs?
Greetings;
Lots of editing to no avail, b
I am sorry.I didnt read far enough in your post.
Ignore my previous reply.
Sorry
Terry
- Original Message -
From: Terry Christophersen
To: Enhanced Machine Controller (EMC)
Cc:
Sent: Saturday, December 31, 2011 11:00 AM
Subject: Re: [Emc-users] Possible bug in G41-42 stuffs?
.125dia
.125dia tool cutting a .230dia ID will leave you .0525 move
if you are starting in the center of the hole and moving to the edge
I dont know if you are saying that cuttercomp is not working correctly
but I have used it for this application and it works as I think it should.
Terry
___
2011/12/31 Michael Haberler :
>
> hey look, I just decoded some jepler mystery code and found it useful, other
> than that I'm just an MBA ;-)
Thanks!
Ohh, not the right time to try to hide behind the MBA degree :)
I am an MBA too and I have to say that Your work on redefined g-code
commands, the
Problem solved, Thank you!
Regards!
>
> Hi
>
> See Integrator Manual Chap 4.2.8
>
> In [TRAJ] section of ini file, set
>
> DEFAULT_VELOCITY=
> DEFAULT_ACCELERATION=
>
> to figures far lower than your current MAX figures (1/4 at least) and
> experiment from there
>
> Acceleration is the one which
10 matches
Mail list logo