Hi All
I have had this monster servo motor (and drive) collecting dust for a few
years, and still trying to figure out a use for it.
If only the speed was a lot higher, it would be an awesome spindle motor
for rigid tapping.
It has an encoder and brake on it.
Anyone got any novel ideas on what
On 10/02/2018 06:24 PM, robert - Innovative-RC wrote:
Does any one know if the points inbetween nominal values
are interpolated or not in a screw comp table?
ie if i have 10mm nominal and 20mm nominal with correction
values. would say 15mm travel become an interpolated value
for screw comp?
Does any one know if the points inbetween nominal values are
interpolated or not in a screw comp table?
ie if i have 10mm nominal and 20mm nominal with correction values. would
say 15mm travel become an interpolated value for screw comp?
i had a look in motion.c , control.c and command.c
On Tue, Oct 2, 2018 at 12:30 PM theman whosoldtheworld
wrote:
>
> I'm trying to study QtDro and upgrade to the new QT5.11 both in the
> linking library version
> and in the included library version.
>
> Unfortunately I run into two errors that I can not understand:
>
> -1- Inifile inifile; ->
I'm trying to study QtDro and upgrade to the new QT5.11 both in the
linking library version
and in the included library version.
Unfortunately I run into two errors that I can not understand:
-1- Inifile inifile; -> inifile is not declared in these scope ... why?
-2- EMC_NMLFILE is not declared
