There is probably a post processor setting for X axis direction to
accommodate the variation out there.
-- Ralph
From: andy pugh [bodge...@gmail.com]
Sent: Monday, April 11, 2022 10:10 AM
To: Enhanced Machine Controller (EMC)
Subject: Re: [Emc-users]
Horizontals typically follow the same right-hand rule as any other machine,
it's just that the coordinates are turned normal to the spindle direction
(z axis)
Phil T.
The Feral Engineer
Check out my LinuxCNC tutorials, machine builds and other antics at
www.youtube.com/c/theferalengineer
Help
On Mon, 11 Apr 2022 at 18:21, Sam Sokolik wrote:
>
> Lol - I always make sure that when I am visualizing a piece of graph paper
> on the machine - when I command a positive for both x and y - the tool
> would move up and to the right on the paper.. (and Z negative gets the
> tool closer to the
I try to not look at the moving bits - that gets confusing..
On Mon, Apr 11, 2022 at 12:18 PM Sam Sokolik wrote:
> Lol - I always make sure that when I am visualizing a piece of graph paper
> on the machine - when I command a positive for both x and y - the tool
> would move up and to the right
Lol - I always make sure that when I am visualizing a piece of graph paper
on the machine - when I command a positive for both x and y - the tool
would move up and to the right on the paper.. (and Z negative gets the
tool closer to the part)
sam
On Mon, Apr 11, 2022 at 12:07 PM Todd Zuercher
On Mon, 11 Apr 2022 at 18:07, Todd Zuercher wrote:
>
> I bet that there are a lot of horizontals out there configured backwards.
> (Had never really thought about it myself, never worked with one.)
I only noticed when I tried using CAM-generated code on a
non-symmetrical part with the origin
I bet that there are a lot of horizontals out there configured backwards. (Had
never really thought about it myself, never worked with one.)
Todd Zuercher
P. Graham Dunn Inc.
630 Henry Street
Dalton, Ohio 44618
Phone: (330)828-2105ext. 2031
-Original Message-
From: andy pugh
Sent:
I realised last night that the coordinate system on my mill is
incorrect when I run the horizontal spindle.
Curiously nearly every diagram that I can find online also seems to be
incorrect. Or, at least, ambiguous.
https://images.app.goo.gl/XuzUowMJyK3ffabD9 = Ambiguous
It's a DE9. DB is the 25 pin size used for the large serial port, parallel
ports, and old Macintosh SCSI.
A is 15 pin, used mainly for PC gameports and old Macintosh monitors. C is 37
pin, most commonly used for old PC external floppy drives. D is a three row 50
pin connector, uncommonly used
OK, I tried putty with 2 & 3 tied together and it loops back and shows
keystrokes while tied. So the NUC's RS232 port IS functional.
I found an FTDI USB RS232 but it ends in female pins, I need male.
Found a knockoff PL2303 USB-to-DB9 cable, I hope it's RS232 level, it
does end in a DB9. No
10 matches
Mail list logo
