ursday, August 16, 2018 12:07 PM
To: Todd Zuercher
Subject: Re: [Emc-users] Linuxcnc vs Mach3 for Plasma Cutter?
I have a lot of customers running both Mach3 and LinuxCNC. Setting up THC with
LinuxCNC is not very well documented so it is quite a bit of work. However once
set up in my opinion it
-
From: Dave Cole
Sent: Tuesday, August 14, 2018 5:03 PM
To: emc-users@lists.sourceforge.net
Subject: Re: [Emc-users] Linuxcnc vs Mach3 for Plasma Cutter?
Mach3 is now pretty old.
Is there a legit license installed with the software?
Oftentimes machines were shipped with a demo license only
worst nightmare and that is one big reason I install Mach
and then remove the menus once done.
-- Original Message --
From: "Todd Zuercher"
To: "Enhanced Machine Controller (EMC)"
Sent: 2018-08-14 22:11:30
Subject: [Emc-users] Linuxcnc vs Mach3 for Plasma C
[Emc-users] Linuxcnc vs Mach3 for Plasma Cutter?
Mach3 is now pretty old.
Is there a legit license installed with the software?
Oftentimes machines were shipped with a demo license only. (limited Gcode
support)
CandCNC used to sell a lot of Mach3 software with their systems.
Go look at thei
Mach3 is now pretty old.
Is there a legit license installed with the software?
Oftentimes machines were shipped with a demo license only. (limited
Gcode support)
CandCNC used to sell a lot of Mach3 software with their systems.
Go look at their site now.
If it works... why change it? Chances
I don’t want to start a big Mach bashing. I just want to hear some opinions
from those who have set up a simple CNC plasma machine with both Mach and
Linuxcnc.
Are there any inherent advantages/disadvantages of one over the other for a
plasma cutter?
Here where I work they just purchased a
