On Saturday, December 31, 2011 11:57:46 PM dave did opine:
> Hm! Maybe half that ... 0.0525 center to center. :-)
>
And precisely the figure I used when I said to heck with this and wrote it
by hand. But I used a g3 for a climb cut, worked perfectly. Then I put an
engraving bit in, set it
Hm! Maybe half that ... 0.0525 center to center. :-)
dave
On Sat, 31 Dec 2011 00:55:20 -0500
gene heskett wrote:
> Greetings;
>
> Lots of editing to no avail, but I believe I have a clue to the
> G41-42 problem. The preset radius is for a .230" diameter circle,
> but if I use a .125 mill
On Saturday, December 31, 2011 03:38:48 PM Terry Christophersen did opine:
> Your New Years eve sounds as exciting as mine
ROTFL! But, I can remember 50 or 60 years back, doing New Years Eve up
right. But for the life of me, I can't remember why...
> I am running some small parts on my Hardin
To: emc-users@lists.sourceforge.net
Cc:
Sent: Saturday, December 31, 2011 1:21 PM
Subject: Re: [Emc-users] Possible bug in G41-42 stuffs?
On Saturday, December 31, 2011 01:48:48 PM Terry Christophersen did opine:
> .125dia tool cutting a .230dia ID will leave you .0525 move
> if y
On Saturday, December 31, 2011 01:48:48 PM Terry Christophersen did opine:
> .125dia tool cutting a .230dia ID will leave you .0525 move
> if you are starting in the center of the hole and moving to the edge
This is I believe the crux of the problem. This code generator does not
start at the
Sorry , ignore my reply I didnt read far enough
Sorry Everybody
Terry
- Original Message -
From: gene heskett
To: emc-users@lists.sourceforge.net
Cc:
Sent: Friday, December 30, 2011 11:55 PM
Subject: [Emc-users] Possible bug in G41-42 stuffs?
Greetings;
Lots of editing to no avail
I am sorry.I didnt read far enough in your post.
Ignore my previous reply.
Sorry
Terry
- Original Message -
From: Terry Christophersen
To: Enhanced Machine Controller (EMC)
Cc:
Sent: Saturday, December 31, 2011 11:00 AM
Subject: Re: [Emc-users] Possible bug in G41-42 stuffs
From: gene heskett
To: emc-users@lists.sourceforge.net
Sent: Friday, December 30, 2011 11:55 PM
Subject: [Emc-users] Possible bug in G41-42 stuffs?
Greetings;
Lots of editing to no avail, but I believe I have a clue to the G41-42
problem. The preset radius is for a .230
Greetings;
Lots of editing to no avail, but I believe I have a clue to the G41-42
problem. The preset radius is for a .230" diameter circle, but if I use a
.125 mill, it errors out and will not load the code.
So, switching to the G41.1 Dnn.nn mode, the error is triggered even by a
g41.1 D0.00