I doubt this will be an issue. I did an application a while back
(years) incrementing a position in hal for a linear drive that was
actually a chain loop. So the servo motor always ran in the same
direction. Rollover of the position counter was brought up then and
calculations were made. I
ay, December 13, 2017 7:16 AM
To: Enhanced Machine Controller (EMC)
Subject: Re: [Emc-users] synchronized servo motors with phase control
On 13 December 2017 at 15:08, John Kasunich wrote:
> One thing to be aware of: If your application runs the motors in the same
> direction for long peri
On 13 December 2017 at 15:08, John Kasunich wrote:
> One thing to be aware of: If your application runs the motors in the same
> direction for long periods of time, absolute position will keep increasing
> even though relative position doesn't change. If HAL still uses single
> precision (32b
One thing to be aware of: If your application runs the motors in the same
direction for long periods of time, absolute position will keep increasing even
though relative position doesn't change. If HAL still uses single precision
(32bit) floats, you eventually might start losing resolution. I
On 13 December 2017 at 03:21, Ralph Stirling
wrote:
> We have a project requiring four servo motors run synchronously, with
> the ability to adjust the phase angle between motors. The motors will
> be ramped up and down in velocity (remaining synchronized), but with
> programmable phase offsets.
We have a project requiring four servo motors run synchronously, with
the ability to adjust the phase angle between motors. The motors will
be ramped up and down in velocity (remaining synchronized), but with
programmable phase offsets. We will be using AutomationDirect 400W
servos, with 1 p