Yep, and usually on maximum so I get a bit of black border.
alan
Or do you always work on the full image area and crop it
later? (Arguably this is an easier way to work.)
Regards,
Alan T
work on the full image area and crop it
later? (Arguably this is an easier way to work.)
Regards,
Alan T
- Original Message -
From: Alan Womack [EMAIL PROTECTED]
To: Majordomo leben.com [EMAIL PROTECTED]
Sent: Sunday, January 14, 2001 4:19 PM
Subject: re: filmscanners: VueScan 6.4.x
Try increasing the preview dpi and see if you get a closer match between
vuescan and PS.
- Original Message -
From: "Gordon Tassi" [EMAIL PROTECTED]
To: [EMAIL PROTECTED]
Sent: Sunday, January 14, 2001 2:20 PM
Subject: Re: filmscanners: VueScan 6.4.x suggestion
Ed: I foun
Try increasing the preview dpi and see if you get a closer match between
vuescan and PS.
A few days ago Ed told this list that the Preview will rarely match the
scan. Once I found out that the Preview in Vuescan was supposed to be
different than in the other scanning software I have used it
On my scanwit, and I would speculate that other none exposure adjusting scanners as
well, the preview and the scan image are very close. Close enough to use preview mem
while adjusting color settings to get an image that is great in PS and requires very
little tweaking.
alan
I have been
Henry,
I've been doing the same for quit some time now, but with a small
alteration:
I like the autonumbering feature if Vuescan a lot but rescanning will
not allow it if you output every file to VuePrint (or whatever...)
Instead I start with turning OFF the output file before I even do the
Then I scan the slide at the desired resolution. I test
different settings in VueScan and each time performes an Scan Mem When
I'm satisfied with the look within VueScan I switch it on again and do a
last scan mem to output the file. This way I can use the fast scan mem
to tweak VueScan to best
Ed makes us aware ...
I just released VueScan 6.4.9 for Windows, Mac OS and Linux.
...
I seemed to have fixed my previous problem with v.6.4.9 (...
scanning a disk file and it coming up non-rotated and as a negative
...) by restarting Vuescan. (What changed shall remain a mystery, but
I
Ed: I found the same with Vuescan vs. PS 5 for both slides and negatives
on my LS-30. I rescanned but with the brightness set at 1.3 for the slide
and negative rather than .7. The slide was fine, the negative was OK but
with less contrast than the slide.
Gordon
shAf wrote:
Ed makes us