-Original Message-
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]
radio.biz] On Behalf Of Frank Brickle
Sent: Saturday, July 28, 2007 10:14 AM
... (Speaking only for myself again, I continue to do the work
because it makes me an irresistable babe magnet, as everyone will
Ok so I am replying to my own e-mail , just wanted to post an update...
1) The periodic breaks that I observed with VAC 4.06/4.07, where
dependent on the SR ( sample rate ) reported in the VAC control panel
and on the 'MS per interrupt' that I had selected. (I an earlier attempt
to tweak VAC
Al:
Thank you very much for this data. I did make changes between 1.8 and
1.9. I now believe the changes I made were ill considered. When the
dust settles on getting all of the millions of ticks of calibrations
done for each 5000 before it leaves the factory (which is about all we
are
i finish to receive my new SDR-1000.
Yes i know that flex 5000 is here, but i want test SDR Radio and
1000 is at a great price now.
I want install ATU, but i don't find JP1 to cut it.
Where is it? Is there any photo?
Thank's
--
Ruben Navarro Huedo
http://www.palotes.com
It is on the PA board. Refer to the schematics.
http://support.flex-radio.com/Downloads.aspx?id=73
-Tim
-Original Message-
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Ruben Navarro
Huedo
Sent: Monday, July 30, 2007 4:11 PM
To: flexradio@flex-radio.biz
Subject:
Thank's a lot.
Running my sdr-1000 fine now.
RX is all fine.
A little question about tx:
PA 100 is installed.
I have done some FM and AM power tests on the bands.
I can see only 20wats of max power in the Powersdr meter.
is this Ok?
What am i doing bad?
Thank's a lot !
Tim Ellison escribió:
It
Dear FLEX-5000 customers,
Please refer to my previous post from July 25th:
http://www.mail-archive.com/flexradio@flex-radio.biz/msg17159.html.
Here is the status of each of the open items discussed in the previous
FLEX-5000 production status:
1) Accurate SWR calibration by band - completed and
Hmmm. Page 62 of the Operating Manual says
DO NOT OPERATE THE 100W AMPLIFIER ABOVE 40W IN
CONTINUOUS CARRIER MODES (E.G. CW, AM, FM, AND
DIGITAL) FOR LONGER THAN 15 SECONDS. HIGHER LEVELS
CAN CAUSE DAMAGE TO THE AMPLIFIER. THE AMPLIFIER IS
RATED AT 100W PEP FOR SSB DUTY CYCLES.
Is your Drive
8 matches
Mail list logo
