We had a few postings recently as how the CAT just plain stops working
on Mix W.
Well, since switching from preview 7 to preview 12, it seems to have
gotten worse. Worse to the point its screwing up the logging as it is
now more often not working (and, hence, records the frequency wrong)
Richard,
I had the same problem two days ago. I tried
everything but could not get the MOX to stop
closing on SSB every time I turned to the Power
Console Then I noticed my mouse did not move
when I started the computer. I am using the USB
to parallel adapter. So I re seated all of my
When I saw the comment about the mouse and PTT, I checked my
keyer. I had bumped it and knocked one of the paddles off its hinge shorting
it out. I put it back on its pivot and everything works. Dumb mistake, but Ill
bet it wont be the last time for that or a stuck mike button.
Thanks
Need help on setting up the SDR-1000 with the Icom PW-1 amplifier.
Any comments would be appreciated, or send me your telphone number and i will
call you.
73's , Bruce
KL7JDR
Bruce W. Mills
P.O. Box 1500
Soldotna, Alaska
99669 - USA
(907)262-4373
[EMAIL PROTECTED]
Richard,
Check
the Hardware Config tab of the Setup form to see if USB Adapter has gotten
unchecked. That will cause the symtom you are seeing.
Bob,
K5KDN
-Original Message-From:
[EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]On Behalf Of Richard
StoufferSent: Thursday,
Richard,
The only really dumb mistakes are the ones
that get you killed. All the others are learning experiences
Glad you go it working.
-Tim
---
Tim Ellison ( [EMAIL PROTECTED] )
Integrated Technical Services ( http://www.itsco.com )
From:
[EMAIL PROTECTED]
In Version 12 the playback level for wave files is extremely high.
Bill Nagle
[EMAIL PROTECTED]
Fred, Richard, Joe, Ignacio, et al,
I received a good natured private e-mail last night
chiding me for turning the SDR-1000 forum into an
SWL'ers mystery signal forum. But I think that this
thread should be of interest to the general SDR-1000
population for at least a couple of reasons.
Not all
Does anyone know the pin out for the 8-pin mic
conn? All the references I've seen
in the manuals refer to 4 pin conn. I know
thatpins 78 are audio and 56 are keying
butthe cable ends are covered and I'm unable
totell which are the hot leads. Yes,
I know it doesn't matter as far as keying as
Hulen,
The pinouts for all microphone connector configurations
can be found in the operating manual in Chapter 4 (pg 15).
Eric Wachsmann
FlexRadio Systems
-Original Message-
From:
[EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Hulen Smith
Sent: Friday,
10 matches
Mail list logo