In article pine.gso.3.95q.990503053948.19300a-100...@rac1.wam.umd.edu,
Kenneth Wayne Culver culv...@wam.umd.edu writes:
As we probably all know, Q3 test is out for Linux. I tested it on FreeBSD,
with great results. I just downloaded the correct glide libraries from the
site suggested
Geoff Buckingham wrote:
In article pine.gso.3.95q.990503053948.19300a-100...@rac1.wam.umd.edu,
Kenneth Wayne Culver culv...@wam.umd.edu writes:
As we probably all know, Q3 test is out for Linux. I tested it on FreeBSD,
with great results. I just downloaded the correct glide
yacine wrote:
I have problems with sound myself. I get an error message in the
Q3A
console saying your soundcard can't do this. I have a Crystal CS4237B
soundcard.
snip...
controller pnp0# this is required for PnP support
device pcm0at isa? port ? tty irq 9 drq 1
On 05-May-99 yacine wrote:
I have problems with sound myself. I get an error message in the Q3A
console saying your soundcard can't do this. I have a Crystal CS4237B
soundcard. Here is information from my dmesg:
This probably happens because pcm doesn't support mmap'ing the DMA buffers of
On 04-May-99 Eric Hodel wrote:
I think it is because the pcm driver don't support mmap()ing. Are we
going to get mmap()ing? (If this is the case.)
Actually.. I wouldn't mind a library you can LD_PRELOAD which replaces
open/read/write/mmap/ioctl for audio devices and then mangles it to an
As we probably all know, Q3 test is out for Linux. I tested it on FreeBSD,
with great results. I just downloaded the correct glide libraries from the
site suggested by Carmac (Q3 programmer) and installed those, and then I
added the appropriate resoulutions to my configuration.
Kenneth Culver
On Mon, 3 May 1999, Kenneth Wayne Culver wrote:
As we probably all know, Q3 test is out for Linux. I tested it on FreeBSD,
with great results. I just downloaded the correct glide libraries from the
site suggested by Carmac (Q3 programmer) and installed those, and then I
added the appropriate
Kenneth Wayne Culver wrote:
As we probably all know, Q3 test is out for Linux. I tested it on FreeBSD,
with great results. I just downloaded the correct glide libraries from the
site suggested by Carmac (Q3 programmer) and installed those, and then I
added the appropriate resoulutions to my
