Hi all, I just found problems writing audio-CDs under -current <FreeBSD 5.0-CURRENT #3: Thu Nov 28 21:59:11 CET 2002>.
These problems don't occur writing ISO-(Data-)files nor do they occur writing audio-CDs or Data-iso-files under -STABLE. I append the standard-output of the 'cdrecord'-command below, SCSI-Controller is a LSI Logic U-SCSI model using the sym-driver. 'dmesg | grep sym1' says: sym1: <875> port 0xe000-0xe0ff mem 0xe3003000-0xe3003fff,0xe3002000-0xe30020ff irq 15 at device 10.0 on pci0 sym1: Symbios NVRAM, ID 7, Fast-20, SE, parity checking sym1: open drain IRQ line driver, using on-chip SRAM sym1: using LOAD/STORE-based firmware. sym1: SCAN AT BOOT disabled for targets 8 9 10 11 12 13 14 15. sym1: SCAN FOR LUNS disabled for targets 0 1 2 3 4 5 6 8 9 10 11 12 13 14 15. (noperiph:sym1:0:-1:-1): SCSI BUS reset delivered. sa0 at sym1 bus 0 target 4 lun 0 da4 at sym1 bus 0 target 0 lun 0 cd1 at sym1 bus 0 target 5 lun 0 cd0 at sym1 bus 0 target 3 lun 0 ... where 'cd1' is the YAMAHA CRW4416 drive. And here is the cdrecord-session: root@current - /raid/audio/tmp 111 # cdrecord -dummy dev=1,5,0 -dao -useinfo -text *.wav pregap1: -1 Cdrecord 1.11a39 (i386-unknown-freebsd5.0) Copyright (C) 1995-2002 Jörg Schilling scsidev: '1,5,0' scsibus: 1 target: 5 lun: 0 Using libscg version 'schily-0.7' Device type : Removable CD-ROM Version : 2 Response Format: 2 Capabilities : SYNC Vendor_info : 'YAMAHA ' Identifikation : 'CRW4416S ' Revision : '1.0j' Device seems to be: Generic mmc CD-RW. Using generic SCSI-3/mmc CD-R driver (mmc_cdr). Driver flags : MMC SWABAUDIO Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R96R Starting to write CD/DVD at speed 4 in dummy SAO mode for single session. Last chance to quit, starting dummy write 0 seconds. Operation starts. SAO startsec: -11615 cdrecord: Input/output error. write_g1: scsi sendcmd: retryable error CDB: 2A 00 FF FF D2 A1 00 02 9A 00 status: 0x2 (CHECK CONDITION) Sense Bytes: 70 00 05 00 00 00 00 0A 00 00 00 00 21 00 00 00 00 00 00 00 00 00 00 08 00 00 00 00 00 00 08 00 Sense Key: 0x5 Illegal Request, Segment 0 Sense Code: 0x21 Qual 0x00 (logical block address out of range) Fru 0x0 Sense flags: Blk 0 (not valid) resid: 63936 cmd finished after 0.003s timeout 200s write CD-Text data: error after 0 bytes cdrecord: Could not write Lead-in. Are these error messages of any use for anybody? -- Ciao/BSD - Matthias Matthias Schuendehuette <msch [at] snafu.de>, Berlin (Germany) Powered by FreeBSD 5.0-CURRENT To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-current" in the body of the message