Hi
Does anyone know the IPv6 vesion of the command that would be of the form
gifconfig_gif0=fec0::1 fec0::2
that would set up the two physical ends of a tunnel?
Sadly the above does not works as it does not recognise the IPv6 address
as there is no
ipv6_gifconfig_gif0=fec0::1 fec0::2
to
On Sun, Mar 23, 2008 at 5:35 AM, Malcolm Clarke
[EMAIL PROTECTED] wrote:
Hi
Does anyone know the IPv6 vesion of the command that would be of the form
gifconfig_gif0=fec0::1 fec0::2
that would set up the two physical ends of a tunnel?
Sadly the above does not works as it does not
Dear Kevin
Many thanks.
Maybe this can make it to the next release to fill a gap.
Regards
Malcolm
Kevin Downey wrote:
On Sun, Mar 23, 2008 at 5:35 AM, Malcolm Clarke
[EMAIL PROTECTED] wrote:
Hi
Does anyone know the IPv6 vesion of the command that would be of the form
Malcolm Clarke wrote:
We are trying to configure an IPv6 tunnel for IPSec, ie IPv6 in IPv6.
The command line would be
ifconfig gif0 inet6 tunnel src-addr dst_addr (IPv6 addresses)
There appears to be no equivalent line for rc.conf.
Regards
Malcolm
To configure an if_gif interface for IPv6
Dear Bruce
Thank you for a prompt response.
The command you give will set the two ends of the GIF connection and we
are using it, but it is not the command that sets the physical ends of
the tunnel.
We would expect something of the form
gifconfig_gif0=fec0::1 fec0::2
but there appears to