Hi, Having a SCSI Geometry issue on a 5.2.1-RELEASE-p4 system. It has a Symbios SDMS PCI SCSI, 53C1010-66 adapter that shows up as :
sym0: <1010-66> port 0xa000-0xa0ff mem 0xf6000000-0xf6001fff,0xf6800000-0xf68003 ff irq 25 at device 5.0 on pci1 sym0: Symbios NVRAM, ID 7, Fast-80, LVD, parity checking sym0: open drain IRQ line driver, using on-chip SRAM sym0: using LOAD/STORE-based firmware. sym0: handling phase mismatch from SCRIPTS. And to it I'm connecting an EasyRaid II RAID box. There is LITTLE I can configure on it, basically termination, SCSI ID, and Raid 0/1/0+1/3/5 and thats pretty much it. When the system boots, the splash screen claims the geometry is 1024/255/63 at 40M sync, and 16 wide. In the controller I've used "Alternate CHS Mapping" and "SCSI Plug and Play Mapping" without any differences. When FreeBSD boots, it sees : (noperiph:sym0:0:-1:-1): SCSI BUS reset delivered. da0 at sym1 bus 0 target 3 lun 0 da0: <easyRAID II > Fixed Direct Access SCSI-2 device da0: 40.000MB/s transfers (20.000MHz, offset 31, 16bit), Tagged Queueing Enabled da0: 1060184MB (2171256832 512 byte sectors: 255H 63S/T 135154C) When I try to /stand/sysinstall it, fdisk pitches a serious fit about it. What can I do to get this configured properly? It seems that if I bring it down to RAID-1+0, it configures up fine. Thanks, Tuc/TTSG Internet Services, Inc. _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"