Yes, I did that, I use standard vias, 0.01 drill. 0.025 pad, no micro, no
buried, no blind.
I just need to specify different pad size (or remove) on inner layer.
Mike Sharkey <[EMAIL PROTECTED]> wrote:
> I'm not sure how to go back and correct, but when you initially setup your
> Via param
I'm not sure how to go back and correct, but when you initially setup your
Via parameters Dimensions->Tracks_and_Vias you can use the radio buttons
to select which vias you're talking about, either Standard Via, Blind Via,
or Burried Via.
Mike Sharkey
Pike Aerospace Research Corporation
www.pikeae
I did not find any way of doing it either without resorting to gerber changes.
It seems that the house does not like small pads on inside layers, their
program checks for copper around the hole and flags it as an error.
They require larger pads on inside layers (>= 0.012 all around) and smaller (>
Hi,
I am not sure that this is possible. Vias and through hole components
have pad for every layer. Try to edit the files with a Gerber editor and
trim the pads . Could you send a visual representation of the DRC ? Most
likely you will have to rework the problem zones.
Regards
On Fri, 2008-05-16
My PCB house DRC check complains about vias having pads on inner layers.
How to have via pads on the outside and no pads inside the board on 4
layer board?
The inner pads are not connected to anything and do not hurt anything
but I get over 500 errors that I want to clean up.
Martin
