KR> Spinner bulkheads

Netters I have tried to roll the flange for my spinner bulkhead on my lathe and it is not working. The first attempt was 2024T3 .050. I clamped it between 2 pieces of 3/4" particle board and bolted it on a face plate. Using a large ball bearing mounted on my toolpost I managed to roll it

KR> Weight and balance

Netters One more weight and balance question. Where should the CG be on an empty airplane? My KR2 plans say the CG envelope is 4" ahead of the aft side of the front spar to 4" behind it.By moving my battery and ELT as far back in the tail as I can, I come out right at the forward CG. When I

KR> more Revmaster questions

Dan The Revmaster site is www.revmasteraviation.com Ralph Snyder Burbank CA ralphnd...@juno.com On Wed, 29 Jun 2005 18:32:54 -0400 (Eastern Daylight Time) "Dan Heath" writes: > Anybody know the site for Revmaster?

KR> Belly board mounting

or strength. The front spar is too far forward. mine > is on > the front side of the rear spar. Here is a link to my details. > http://mywebpage.netscape.com/n886mj/bellyboard.html > > Mark Jones (N886MJ) > Wales, WI > > - Original Message - > From: "Ralph H S

KR> Belly board mounting

I want to mount the belly board between the front and rear spar. I can't mount it behind the rear spar because that is my luggage compartment. I searched 235 messages in the archives and only 2 were mounted ahead of the rear spar. One was 4" behind the front spar and the other was somewhere in

KR> West Coast Gathering

I live in Burbank, and would be interested in a west coast gathering. KR2 at 95 % Ralph Snyder

KR> Outside air temperature probe

Could someone tell me where the best place is to install my outside air temperature probe. Does it need to be in dead air for a correct reading, or will it read correct in the airstream? I was thinking of putting it through the bottom so it will not be in direct sunlight. Thanks Ralph Snyder

KR>Gatherings - wakeup call

Dana wrote Gang, sorry for the post. I just had enough of the dialogue. My apologies for the public display. Dana Keep your post's coming, whether KR or RV. We enjoy them both. Ralph Snyder Burbank CA

KR>Re: Bolt Size

The bolt size is 1 1/8 x 5" NC. Drill and tap the threaded end of the bolt for 1/2" NC and install a bolt in it. Cut the 1/2" bolt off 2 1/4" long and taper the end the same angle as a drill bit. This will pop it off with no problem. Ralph Snyder Burbank, CA On Sun, 18 Jan 2004 13:30:20 -0500

KR>Finishing

Stephen Mines Please e-mail me off net. I would like to give you a call and see your KR 2. Ralph Snyder Burbank CA ralphnd...@juno.com