: Thursday, December 20, 2012 10:25 PM
Subject: KR> aileron linkage bearing ends. elevator hinges per plans or double
up on hinges
what bearing end are most kr builders using on ailerons heim aurora hfe ect.
are most builders using plans for elevator, rudder hinges or are they doubling
up on
what bearing end are most kr builders using on ailerons heim aurora hfe ect.
are most builders using plans for elevator, rudder hinges or are they doubling
up on hinges. wing question i believe wings for my project are the rf48 airfoil
was considering
My Acro Sport had bent pushrods like you are describing so they would clear
the bottom of the rear spar. To me the linkage rod off the bellcrank could
have been made slightly longer so you would have had a straight pushrod
though
Fred Johnson
Reno, NV
Larry wrote:
I have seen a couple of
I have seen a couple of KRs where this linkage (the rod) was bent to accomodate
the proper angle for that plane. I am not saying that this is the best thing to
do, just saying that I have seen that done before.
I am not sure if it matters, but I don't think I would bend mine unless it was
absolu
> I'll go one better, what about these?
>
> http://www.mcmaster.com/#rod-ends/=98sk3x
Since the rod was aluminum, it might have been 1/4-28 threads, now that I
think about it. Somebody's probably got a pair of these somewhere...
Mark Langford
n5...@hiwaay.net
website www.n56ml.com
I'll go one better, what about these?
http://www.mcmaster.com/#rod-ends/=98sk3x
they have right and left hand threads so one simply turns it to adjust the
proper alignment of the ailerons. Granted, it would need to use 1/4 rod
bearings, but if you use the aluminum ones they sell, you are saving e
Mike Sylvester
> Alright Guys, come to my rescue. Am I overlooking what the aileron linkage
> is made of in the plans ?
The short answer to your question is 6061-T6 aluminum.
I'm not really qualified to answer this, since my ailerons are completely
different from what the plans call for, but a
for building and it never seems to end.
Daniel R. Heath - Lexington, SC
-Original Message-
From: krnet-boun...@mylist.net [mailto:krnet-boun...@mylist.net] On Behalf
Of MICHAEL SYLVESTER
Sent: Monday, October 11, 2010 8:50 PM
To: KRNET
Subject: KR> aileron linkage
Alright Guys, come to
Alright Guys, come to my rescue. Am I overlooking what the aileron linkage is
made of in the plans ? What do you make the outside linkage that hooks directly
to the aileron out of ? I need to get the linkages to know how much to notch
out the stub and main wing. Thanks.
Mike Sylvester
kr2s bu
9 matches
Mail list logo
