Wow! on so many different levels! ;-)
C.A.G.
On Wednesday, November 1, 2023 at 11:06:03 AM EDT, cdkr...@gmail.com
wrote:
No motors, non desired. While it's not CNC or even consistentwith my other
motor driven lathe carriages, I'm reluctant to go into
that black hole. It's a hobby,
No motors, non desired. While it's not CNC or even consistent
with my other motor driven lathe carriages, I'm reluctant to go into
that black hole. It's a hobby, a pleasant one, and while i really do
detest tedium, there is a place for it. I've gotten used to breaking
work periods into small
Thank you Dan.
Yes a template would be the best way to do what you are thinking about for the
bulged checkering. If you are going to go through all this troubles to make
this, You might as well start figuring out a better way to keep the pressure on
the spindle when cutting form the side.
Great information Dan.
Looking forward to what you create now that the R-N-D is winding down. Now
putting it in action for products.
Thanks again.
Kind Regards,
Timothy J. Ziegler
Ziegler WoodWork & Specialty
Ziegler Laser Worx LLC
14171 160th Ave.
Foreston MN 56330
320-294-5798 shop
meant to add "unidirectional between stops", yes.
DanK
On Wednesday, November 1, 2023 at 6:32:42 AM UTC-4 cdkr...@gmail.com wrote:
> Mornin' Curt. The cuts were unidirectional and the router turned off for
> the backstroke through the fresh cut, no other changes. Except for
> moving the
Mornin' Curt. The cuts were unidirectional and the router turned off for
the backstroke through the fresh cut, no other changes. Except for
moving the index pin the sync was not broken at any time until the
cross cut setup required changing the reverse gear. Once the RH
cuts were done, then
