On Fri, May 31, 2013 at 20:25:38, Strashko, Grygorii wrote:
On 05/31/2013 01:13 PM, Hebbar Gururaja wrote:
Amend the I2C omap pin controller to optionally take a pin control
handle and set the state of the pins to:
- default on boot, resume and before performing an i2c transfer
- idle
On Fri, May 31, 2013 at 23:04:59, Kevin Hilman wrote:
Hebbar Gururaja gururaja.heb...@ti.com writes:
Amend the I2C omap pin controller to optionally take a pin control
handle and set the state of the pins to:
- default on boot, resume and before performing an i2c transfer
- idle after
On Fri, May 31, 2013 at 8:07 PM, Kevin Hilman khil...@linaro.org wrote:
But that brings up a bigger question about whether or not we should be
doing the rest of this (idle/sleep) pin management in the drivers or in
the driver core as well. I would much prefer it be handled by the
driver
On Fri, May 31, 2013 at 23:37:02, Kevin Hilman wrote:
+Linus Walleij (pinctrl maintainer)
Hebbar Gururaja gururaja.heb...@ti.com writes:
Amend the I2C omap pin controller to optionally take a pin control
handle and set the state of the pins to:
- default on boot, resume and before
Hi Kevin, Gururaja
On 05/31/2013 08:34 PM, Kevin Hilman wrote:
Hebbar Gururaja gururaja.heb...@ti.com writes:
Amend the I2C omap pin controller to optionally take a pin control
handle and set the state of the pins to:
- default on boot, resume and before performing an i2c transfer
- idle
Amend the I2C omap pin controller to optionally take a pin control
handle and set the state of the pins to:
- default on boot, resume and before performing an i2c transfer
- idle after initial default, after resume default, and after each
i2c xfer
- sleep on suspend()
By optionally putting the
On 05/31/2013 01:13 PM, Hebbar Gururaja wrote:
Amend the I2C omap pin controller to optionally take a pin control
handle and set the state of the pins to:
- default on boot, resume and before performing an i2c transfer
- idle after initial default, after resume default, and after each
i2c xfer
Hebbar Gururaja gururaja.heb...@ti.com writes:
Amend the I2C omap pin controller to optionally take a pin control
handle and set the state of the pins to:
- default on boot, resume and before performing an i2c transfer
- idle after initial default, after resume default, and after each
i2c