On Fri, Oct 17, 2014 at 12:35:39PM +0200, Marek Szyprowski wrote:
> Hello,
>
> On 2014-10-16 15:33, Felipe Balbi wrote:
> >On Thu, Oct 16, 2014 at 02:57:57PM +0200, Marek Szyprowski wrote:
> >>This patch adds a call to s3c_hsotg_disconnect() from 'end session'
> >>interrupt to correctly notify gad
On Fri, Oct 17, 2014 at 11:02:34AM -0500, Felipe Balbi wrote:
> On Fri, Oct 17, 2014 at 10:49:25AM -0500, Felipe Balbi wrote:
> > On Fri, Oct 17, 2014 at 10:46:30AM -0500, Felipe Balbi wrote:
> > > Hi,
> > >
> > > On Fri, Oct 17, 2014 at 10:44:35AM -0500, Felipe Balbi wrote:
> > > > On Fri, Oct 17
Enable rtc and watchdog support for exynos7 SoCs.
Signed-off-by: Abhilash Kesavan
---
arch/arm64/Kconfig |3 +++
1 file changed, 3 insertions(+)
diff --git a/arch/arm64/Kconfig b/arch/arm64/Kconfig
index 238acff..9bb4e02 100644
--- a/arch/arm64/Kconfig
+++ b/arch/arm64/Kconfig
@@ -158,6 +15
From: Naveen Krishna Ch
Add clock support for the RTC block in Exynos7.
Signed-off-by: Naveen Krishna Ch
Signed-off-by: Abhilash Kesavan
---
.../devicetree/bindings/clock/exynos7-clock.txt|1 +
drivers/clk/samsung/clk-exynos7.c | 54
include/dt-
Add nodes for 3 mmc channels, 12 i2c channels, rtc, and watchdog
on Exynos7.
Signed-off-by: Naveen Krishna Ch
Signed-off-by: Abhilash Kesavan
---
arch/arm64/boot/dts/exynos/exynos7-espresso.dts | 41
arch/arm64/boot/dts/exynos/exynos7.dtsi | 256 +++
2 files
From: Naveen Krishna Ch
Exynos7 supports 3 MMC channels, add the MMC gate clocks to
support them.
Signed-off-by: Naveen Krishna Ch
Signed-off-by: Abhilash Kesavan
---
.../devicetree/bindings/clock/exynos7-clock.txt|3 +
drivers/clk/samsung/clk-exynos7.c | 224 +++
This series adds clock support for I2C, MMC, RTC, Watchdog, TMU and PWM.
It also adds the device nodes for I2C, RTC, WDT, MMC and PMU.
The patchset has been tested on linux-next (20141017) on an Exynos7
Espresso board.
Following are the dependencies:
1) dts, kbuild: Implement support for dtb
From: Naveen Krishna Ch
Exynos7 supports 12 I2C channels, add the I2C gate clocks to
support them.
Signed-off-by: Naveen Krishna Ch
Signed-off-by: Abhilash Kesavan
---
drivers/clk/samsung/clk-exynos7.c | 24
include/dt-bindings/clock/exynos7-clk.h | 16 +
Adds PMU DT node for exynos7 SoC.
Signed-off-by: Abhilash Kesavan
---
.../devicetree/bindings/arm/samsung/pmu.txt|1 +
arch/arm64/boot/dts/exynos/exynos7.dtsi|5 +
2 files changed, 6 insertions(+)
diff --git a/Documentation/devicetree/bindings/arm/samsung/pmu.txt
From: Naveen Krishna Ch
Add clock support for the watchdog timer, pwm timer and thermal
management unit IPs in Exynos7.
Signed-off-by: Naveen Krishna Ch
Signed-off-by: Abhilash Kesavan
---
drivers/clk/samsung/clk-exynos7.c | 14 ++
include/dt-bindings/clock/exynos7-clk.h |
On Fri, Oct 17, 2014 at 10:49:25AM -0500, Felipe Balbi wrote:
> On Fri, Oct 17, 2014 at 10:46:30AM -0500, Felipe Balbi wrote:
> > Hi,
> >
> > On Fri, Oct 17, 2014 at 10:44:35AM -0500, Felipe Balbi wrote:
> > > On Fri, Oct 17, 2014 at 12:43:48PM +0200, Marek Szyprowski wrote:
> > > > Hello,
> > > >
On Fri, Oct 17, 2014 at 10:46:30AM -0500, Felipe Balbi wrote:
> Hi,
>
> On Fri, Oct 17, 2014 at 10:44:35AM -0500, Felipe Balbi wrote:
> > On Fri, Oct 17, 2014 at 12:43:48PM +0200, Marek Szyprowski wrote:
> > > Hello,
> > >
> > > On 2014-10-16 15:36, Felipe Balbi wrote:
> > > >On Thu, Oct 16, 2014
Hi,
On Fri, Oct 17, 2014 at 10:44:35AM -0500, Felipe Balbi wrote:
> On Fri, Oct 17, 2014 at 12:43:48PM +0200, Marek Szyprowski wrote:
> > Hello,
> >
> > On 2014-10-16 15:36, Felipe Balbi wrote:
> > >On Thu, Oct 16, 2014 at 02:57:59PM +0200, Marek Szyprowski wrote:
> > >>Enabling and disabling usb
On Fri, Oct 17, 2014 at 12:43:48PM +0200, Marek Szyprowski wrote:
> Hello,
>
> On 2014-10-16 15:36, Felipe Balbi wrote:
> >On Thu, Oct 16, 2014 at 02:57:59PM +0200, Marek Szyprowski wrote:
> >>Enabling and disabling usb gadget by writing to
> >>/sys/class/udc/*hsotg/soft_connect results in calling
Hello Mark,
On 10/17/2014 03:54 PM, Mark Brown wrote:
> On Fri, Oct 17, 2014 at 02:39:15PM +0200, Javier Martinez Canillas wrote:
>
>> Just to be sure I understood correctly, are you suggesting something like
>> this?
>
>> ldo1_reg: LDO1 {
>> regulator-name = "vdd_1v0";
>>
On Fri, Oct 17, 2014 at 02:39:15PM +0200, Javier Martinez Canillas wrote:
> Just to be sure I understood correctly, are you suggesting something like
> this?
> ldo1_reg: LDO1 {
> regulator-name = "vdd_1v0";
> regulator-min-microvolt = <100>;
>
On Thu, Oct 16, 2014 at 06:48:49PM +0200, Javier Martinez Canillas wrote:
> The only operating modes that are supported by the regulators in the
> max77802 PMIC are Output ON (normal) and Output On in Low Power Mode.
> OFF was wrongly counted as an operating mode while is only a regulator
> status.
On Thu, Oct 16, 2014 at 06:48:50PM +0200, Javier Martinez Canillas wrote:
> Add a header file for the max77802 constants that could be shared between
> the regulator driver and Device Tree source files. Also, remove standby
> and off opmodes since only normal and low power are valid operating modes
On Thu, Oct 16, 2014 at 06:48:48PM +0200, Javier Martinez Canillas wrote:
> The max77802 PMIC has a special enable pin (PWRREQ) that can be used
> by the Application Processor (AP) to power down and up voltage rails.
Applied, thanks.
signature.asc
Description: Digital signature
On Thu, Oct 16, 2014 at 06:48:47PM +0200, Javier Martinez Canillas wrote:
> Some max77802 LDOs (1, 3, 20 and 21) support to be configured in Low
> Power Mode during system normal operation. Add function handlers for
> the .get_mode and .set_mode operations to set the mode on these LDOs.
Applied, t
Hello Mark,
On 10/17/2014 01:57 PM, Mark Brown wrote:
> On Thu, Oct 16, 2014 at 06:48:51PM +0200, Javier Martinez Canillas wrote:
>
>> +- maxim,regulator-initial-mode: initial operating mode.
>> + This property can only be used on regulators that support changing their
>> mode
>> + during norm
On Wed, Oct 15, 2014 at 4:35 AM, Joonyoung Shim wrote:
> Hi,
>
> Kevin Hilman kernel.org> writes:
>
>>
>> Hi Abhilash,
>>
>> Abhilash Kesavan samsung.com> writes:
>>
>> > I had noticed a similar issue where only 6 cores would come up during
>> > development on 5420. This was because there was a
On Thu, Oct 16, 2014 at 06:48:51PM +0200, Javier Martinez Canillas wrote:
> +- maxim,regulator-initial-mode: initial operating mode.
> + This property can only be used on regulators that support changing their
> mode
> + during normal operation. These regulators are LDO1, LDO3, LDO20 and LDO21.
Hello,
On 2014-10-16 15:36, Felipe Balbi wrote:
On Thu, Oct 16, 2014 at 02:57:59PM +0200, Marek Szyprowski wrote:
Enabling and disabling usb gadget by writing to
/sys/class/udc/*hsotg/soft_connect results in calling udc_start/udc_stop
functions with the same usb gadget driver, so the driver sho
Hello,
On 2014-10-16 15:33, Felipe Balbi wrote:
On Thu, Oct 16, 2014 at 02:57:57PM +0200, Marek Szyprowski wrote:
This patch adds a call to s3c_hsotg_disconnect() from 'end session'
interrupt to correctly notify gadget subsystem about unplugged usb
cable.
Signed-off-by: Marek Szyprowski
---
Hi Lorenzo,
On Wed, Oct 15, 2014 at 2:30 PM, Lorenzo Pieralisi
wrote:
> On Wed, Oct 15, 2014 at 07:35:20AM +0100, Chander Kashyap wrote:
>> Exynos7 has core power down state where cores can be powered off
>> independently.
>> This patch adds support for this state.
>
> Please tell us more about
On Thu, 16 Oct 2014, Javier Martinez Canillas wrote:
> Add a header file for the max77802 constants that could be shared between
> the regulator driver and Device Tree source files. Also, remove standby
> and off opmodes since only normal and low power are valid operating modes.
>
> Signed-off-by
27 matches
Mail list logo