Here is the output from lspci on my board
*00:00.0 Host bridge: VIA Technologies, Inc. VT8601 [Apollo ProMedia]
(rev 05)
00:01.0 PCI bridge: VIA Technologies, Inc. VT8601 [Apollo ProMedia AGP]
00:11.0 ISA bridge: VIA Technologies, Inc. VT8231 [PCI-to-ISA Bridge]
(rev 10)
00:11.1 IDE interface: VI
----------
Ronald G. Minnich wrote:
On Sat, 4 Dec 2004, Luc Belliveau wrote:
Same thing, with one small difference... I turned debugging on and this is
what I get :
hmm.
find_ide_controller: found PCI IDE controller 1106:0571 prog_if=0x8f
find_ide_con
Same thing, with one small difference... I turned debugging on and this
is what I get :
find_ide_controller: found PCI IDE controller 1106:0571 prog_if=0x8f
find_ide_controller: primary channel: native PCI mode
find_ide_controller: cmd_base=0x0 ctrl_base=0x0
ide_software_reset: Waiting for ide0 t
umm.. ok now FILO loads, but I get "IDE channel 0 not found"
Ronald G. Minnich wrote:
On Fri, 3 Dec 2004, Luc Belliveau wrote:
Oh, ok. I just tried an etherboot payload, and that loads. So it must be my
FILO config. .. I don't even get the boot: prompt.. I'm going
yes, that could help.
Thanks
Luc
Ronald G. Minnich wrote:
On Fri, 3 Dec 2004, Luc Belliveau wrote:
Oh, ok. I just tried an etherboot payload, and that loads. So it must be my
FILO config. .. I don't even get the boot: prompt.. I'm going to try the
etherboot ide_disk maybe and an
Oh, ok. I just tried an etherboot payload, and that loads. So it must
be my FILO config. .. I don't even get the boot: prompt..
I'm going to try the etherboot ide_disk maybe and and see what that does.
Any ideas what's going on with FILO?
Luc Belliveau wrote:
Thanks for the
ere yet.
At present, I'm trying to clean up the southbridge code.
Regards
Mark.
Quoting "Ronald G. Minnich" <[EMAIL PROTECTED]>:
On Fri, 3 Dec 2004, Luc Belliveau wrote:
I compiled from freebios2 from cvs, when I boot all I get back from
the serial
port is:
LinuxBIOS-1.1.7.0Norm
I compiled from freebios2 from cvs, when I boot all I get back from the
serial port is:
LinuxBIOS-1.1.7.0Normal starting..
vt8601 init starting
Slot 00 is SDRAM 0400 bytes x2
Slot 01 is empty
Slot 02 is empty
Slot 03 is empty
vt8601 is done
0
that's it. I tried changing the DEFAULT_CONSOLE_
8 matches
Mail list logo