Hi All,
I'm working on a M100 that was desperately in need of having the
electrolytic caps replaced. That job was done, and the mess cleaned up. That
being said the power supply section is not working. At one point it did
start working briefly and was outputting a steady 5V and -5V.
The
I like what you did to try to reduce the stress risers as much as possible
for the hooks within the constraints.
bkw
On Sun, Jul 5, 2020, 4:15 PM Steve Glenner wrote:
> Here is the improved 3D printable M200 battery cover:
> https://www.thingiverse.com/thing:4508352
>
> I have made the side
Here is the improved 3D printable M200 battery cover:
https://www.thingiverse.com/thing:4508352
I have made the side tabs a little more robust with a larger radius fillet,
increased the clearance of the short edge tabs, reduced the width and length
vary slightly for easier fit, and added some
So since I acquired a DVI for my M100, I've been wanting to put something
in the empty second drive bay. As I had no blanking cover.
I was just about to get one from arcade shopper, when out of the blue I
find my self bagging a 180kb floppy drive, not just that, it's tested and
refurbed.
Just
My memory of the CPM FCB is that they are there as 8 + 3 characters, padded,
without any '.'. But it was a LONG time ago I actually looked at a CPM FCB.
Which might explain why they are left out of the STARDISK.COM, but I'm just
speculating, never having looked at the program.
Jonathan
