Ok gang here is today's challenges.
92 300TE 4Matic. Rear passenger window just decided it would not go up (NEVER
Been any type of challenge previously) Upon arriving home I went to the rear
door window switch and could hear the motor running but no window movement.
Then I heard a loud
On the 85 300 SD remove the ashtray and look for two phillips screws that
are holding the console in..I think.been a long time.
Zedic
___
http://www.okiebenz.com
For new parts see official list sponsor: http://www.buymbparts.com/
For used parts
To remove the door panel, unscrew the lock button, pull the trim and
window switch out (the black plastic just pries out), remove the
plastic trim around the door latch. Push the plastic bucket for
the door latch forward to unhook it (I think, may be back, it's
obvious), then pry the link
And be sure to put the plastic moisture barrier back
where it was, and if it's shredded or missing, get
some underlayment plastic from Home Despot or Lowe's
and cut out a new one - never, ever, leave this out!
Dan
To remove the door panel, unscrew the lock button,
pull the trim and
window
Any suggestions on where I should start determining why this rear
center console vent is not working?
You're on the right track. The vent knob at the back pulls
on a Bowden cable that runs forwards to the actual flap
that's under the dash. (The air is ducted back.) There's
a joint in the
And be sure to put the plastic moisture barrier back
where it was, and if it's shredded or missing, get
some underlayment plastic from Home Despot or Lowe's
and cut out a new one - never, ever, leave this out!
Hear, hear! (I can't count the number of these I've
had to replace. Far more than
