10/0.10 addr 4
uhidev3: iclass 3/1, 3 report ids
ums1 at uhidev3 reportid 1: 5 buttons, Z dir
wsmouse0 at ums1 mux 0
uhid0 at uhidev3 reportid 2: input=1, output=0, feature=0
uhid1 at uhidev3 reportid 3: input=3, output=0, feature=0
softraid0 at root
root on wd0a swap on wd0b dump on wd0b
cpu1: un
l PRO/1000 MT (82574L)
4:0:0: Matrox MGA G200e (ServerEngines)
On 03/02/2010 02:01 PM, Gleydson Soares wrote:
> can you show the out of the command pcidump !
>
> On Tue, Mar 2, 2010 at 3:53 PM, Ross Davis wrote:
>> I installed OpenBSD 4.6 on an Intel SR1630HGP server that has a
I installed OpenBSD 4.6 on an Intel SR1630HGP server that has an Intel
S3420GPLC board. There are three network interfaces on the server: one
card, and two on the motherboard.
The card is recognized:
em0 at pci1 dev 0 function 0 "Intel PRO/1000 MT (82574L)" rev 0x00: apic
8 int 16
(irq 11), addr
On 12/22/09 4:01 AM, Stijn wrote:
> Ross Davis wrote:
>> I am almost certainly doing something really stupid so hopefully someone
>> can point out where the hole in my brain lies.
>>
>> I have a built a firewall/gateway from using OpenBSD 4.6. The external
>> in
I am almost certainly doing something really stupid so hopefully someone
can point out where the hole in my brain lies.
I have a built a firewall/gateway from using OpenBSD 4.6. The external
interface is 192.168.5.250 which is attached to a DSL router. The
internal interface is 192.168.59.254 whic
On 11/23/09 1:10 AM, Philip Guenther wrote:
> On Sun, Nov 22, 2009 at 9:41 PM, Ross Davis wrote:
>> I am trying to compile bandwidthd 2.0.1 on OpenBSD 4.3. After installing
>> a few needed ports, I was able to run the ./configure command
>> successfully with:
>>
&
I am trying to compile bandwidthd 2.0.1 on OpenBSD 4.3. After installing
a few needed ports, I was able to run the ./configure command
successfully with:
./configure CFLAGS=-lz -x-libraries=/usr/X11R6/lib
However, `make` seems to error out with this message: "Graph cycles
through conf.l.c"
Befor
Monitoring the total bandwidth through the bridge is easy with `bwm-ng`
or `ifstat`. The problem is that I want to see the bandwidth on a per-IP
address basis. I can do this with `ntop` on an interface that has an IP
address, but when I try to use it on the bridge I get:
# ntop -i bridge0
bridge0:
I am running OpenBSD 4.0 and have a bridge set up between two
interfaces: fxp0 and xl0. I would like a program that gives a fairly
basic report on the traffic flowing through this bridge. I am primarily
interested in knowing which IPs on the xl0 side of the bridge are
pulling the most bandwidth.
I
9 matches
Mail list logo