- Forwarded Message -
From: Dhara Buch
To: "ns-users@isi.edu"
Sent: Monday, May 30, 2011 1:42 PM
Subject: Re:[ns]Pausing and Resuming a Method
Hello,
I want to pause a method, say sendRequest, until a specific event occurs. After
the occurrence of the event , the method should be
Hi
Pl check the following site
http://www.wimax360.com/forum/topics/how-to-install-ns229-for-nist?commentId=610217%3AComment%3A138767
It has a zip file with ns2.29 and NIST wimax patch.
rgds
From: hamzah.z
To: ns-users@ISI.EDU
Sent: Tue, May 31, 2011 12
hi
i was able to install the ns-2.29 and nist mobility model from this website
" http://www.nist.gov/itl/antd/emntg/ssm_tools.cfm "
so when i installed it i found that there is a wimax directory inside the
ns-2.29 file watch was in the this folder that i downloaded from
the website ns-nist-
Hi ,
I want to test a geocast routing that i write for vanet in ns2
but I don't know how I can write multicast traffic for it in tcl file?
I want that one node send massage and according to place that sender puts ,
the
place of destination region is specified .
and I don't know how to write t
Hi ,
I want to test a geocast routing that i write for vanet in ns2
but I don't know how I can write multicast traffic for it in tcl file?
I want that one node send massage and according to place that sender puts ,
the
place of destination region is specified .
and I don't know how to write t
Dear Raheel
I have a tcl script witch simulate one access point(802.11), one basestation
wimax and mobile node with 2 interface (one wifi and one wimax). Ihave a
high packet loss rate for wimax. so I think to increase the power ofthe base
station but I obtain always pt_ = 0.28...by doing ./thresh
Hi, folks,
I need a bit of tips here about anycast in ns2. I went through the email
archive and only found a few emails asking this without any answer back to
2002. I assume someone must have done something regarding anycast in ns2. Could
any of you point it out for me, please? Both codes and
Hi NS Users,
Can anyone tell me how to assign different initial energies to nodes? I have
tried configuring each node individially. But for my toplogy
I need different energy classes.
As an example, if there are a total of 50 nodes, I need first 10 nodes with
say 50J of initial energy, next 10 w
The code I used (the first one) was useful only to know WHEN the first node
dies.
When it happens the ns2 must exit, or abort.
Dont know what you exactly need.
On Tue, May 31, 2011 at 2:21 AM, yogesh bansal wrote:
>
> with the help of hemang advice, i changed my code from this
>
> *// MY INCLUDE
LinkedIn
JAYANTHI MURTHY requested to add you as a connection on LinkedIn:
--
Rishabh,
I'd like to add you to my professional network on LinkedIn.
- JAYANTHI
Accept invitation from JAYANTHI MURTHY
http://www.linkedin.com/e/362gef-
10 matches
Mail list logo