with BLE module
- SPI1: On board socket for Zigbee module
Update firmware instructions
Pleae update firmware on uboot web(default 192.168.1.1).
Signed-off-by: Li Zhang
---
package/firmware/ipq-wifi/Makefile | 2 +
.../ipq-wifi/board
Specifications:
- SOC: Qualcomm IPQ4019 ARM Quad-Core
- RAM: 512 MiB
- Flash: 16 MiB NOR - SPI0
- EMMC: 8GB EMMC
- ETH: Qualcomm QCA8075
- WLAN1: Qualcomm Atheros QCA4019 2.4GHz 802.11b/g/n 2x2
- WLAN2: Qualcomm Atheros QCA4019 5GHz
: On board with BLE module
- SPI1: On board socket for Zigbee module
Update firmware instructions
Pleae update firmware on uboot web(default 192.168.1.1).
Signed-off-by: Li Zhang
---
package/firmware/ipq-wifi/Makefile | 2 +
.../ipq-wifi/board
: On board with BLE module
- SPI1: On board socket for Zigbee module
Update firmware instructions
Pleae update firmware on uboot web(default 192.168.1.1).
Signed-off-by: Li Zhang
---
package/firmware/ipq-wifi/Makefile | 2
xxx.img.gz,then update firmware on uboot
web.
Signed-off-by: Li Zhang
---
package/boot/uboot-envtools/files/mvebu| 3 +
.../cortexa53/base-files/etc/board.d/02_network| 3 +-
.../arm64/boot/dts/marvell/armada-gl-mv1000.dts| 165 +
target/linux/mvebu/image
Hi Piotr,Tomasz:
ART has a specific meaning (Atheros Radio Test) and it looks just wrong
here, not just weird.
Why not change it to something less misleading?
Maybe 'factory' or 'vendor'?
Thank you very much for your advise.Next time,I'll change it.
Li Zhang | Software Engineer
li.zh...@gl
Hi Tomasz,
Crucial question is left unanswered: Does the U-Boot by default boot OpenWrt
from
eMMC only or eMMC and SD card? And if boot from both, which is booted first?
---> Boot openwrt from EMMC by default. If boot from both,Emmc is booted first.
Regards,Li
Li Zhang | Software Engin
: 1x USB 2.0 port(TypeA),1x USB 3.0 port(TypeC)
- Button: 1x reset button,1x slide switch
- LED: 3x greed LED
- UART: 1x UART on PCB (JP1: 3.3V, RX, TX, GND)
Signed-off-by: Li Zhang
---
package/boot/uboot-envtools/files/mvebu| 3 +
.../cortexa53/base-files/etc
(typec)
- Button: 1x reset button
- LED: 16x LEDs (3x GPIO controllable)
- UART: 1x UART on PCB (JP1: 3.3V, RX, TX, GND)
Signed-off-by: Li Zhang
---
package/boot/uboot-envtools/files/mvebu| 3 +
.../linux/mvebu/base-files/etc/board.d/02_network | 3
