Hardware -------- CPU: Qualcomm Atheros QCA9558 RAM: 128M DDR2 FLASH: 16MiB ETH: 1x Atheros AR8035 (PoE in) WiFi2: QCA9558 3T3R WiFi5: QCA9880 3T3R BTN: 1x Reset LED: 1x LED blue 1x LED red BUZZ: 1x GPIO attached piezo buzzer (controllable ass LED) UART: 3.3V GND TX RX (115200-N-8) (3.3V is square pad) Header is located next to reset-button
There is also a Micro-B USB-port present but this only seems to be a dummy as the circuit next to it is not present (at least in my unit). It is also not mentioned in the devolo manual. Installation ------------ Make sure you set a password for the root user as prompted on first setup! 1. Upload OpenWRT sysupgrade image via SSH to the device. Use /tmp as the destination folder on the device. User is root, password the one set in the web interface. 2. Install OpenWRT with > sysupgrade -n -F /tmp/<openwrt-image-name> Signed-off-by: David Bauer <m...@david-bauer.net> --- .../ath79/base-files/etc/board.d/02_network | 1 + .../etc/hotplug.d/firmware/11-ath10k-caldata | 3 +- .../ath79/dts/qca9558_devolo_dvl1750c.dts | 46 +++++++++++++++++++ .../ath79/dts/qca9558_devolo_dvl1xxx.dtsi | 2 +- target/linux/ath79/image/generic.mk | 8 ++++ 5 files changed, 58 insertions(+), 2 deletions(-) create mode 100644 target/linux/ath79/dts/qca9558_devolo_dvl1750c.dts diff --git a/target/linux/ath79/base-files/etc/board.d/02_network b/target/linux/ath79/base-files/etc/board.d/02_network index e090396708..594cadb1e1 100755 --- a/target/linux/ath79/base-files/etc/board.d/02_network +++ b/target/linux/ath79/base-files/etc/board.d/02_network @@ -10,6 +10,7 @@ ath79_setup_interfaces() case "$board" in avm,fritz300e|\ + devolo,dvl1750c|\ ocedo,koala|\ ocedo,raccoon|\ pcs,cap324|\ diff --git a/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata b/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata index d1b3bbdcb5..681a397efc 100644 --- a/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata +++ b/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata @@ -87,7 +87,8 @@ board=$(board_name) case "$FIRMWARE" in "ath10k/cal-pci-0000:00:00.0.bin") case $board in - devolo,dvl1200e) + devolo,dvl1200e|\ + devolo,dvl1750c) ath10kcal_extract "art" 20480 2116 ath10kcal_patch_mac $(macaddr_add $(mtd_get_mac_binary art 0) -1) ;; diff --git a/target/linux/ath79/dts/qca9558_devolo_dvl1750c.dts b/target/linux/ath79/dts/qca9558_devolo_dvl1750c.dts new file mode 100644 index 0000000000..20860b6806 --- /dev/null +++ b/target/linux/ath79/dts/qca9558_devolo_dvl1750c.dts @@ -0,0 +1,46 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT +/dts-v1/; + +#include <dt-bindings/gpio/gpio.h> +#include <dt-bindings/input/input.h> + +#include "qca9558_devolo_dvl1xxx.dtsi" + +/ { + compatible = "devolo,dvl1750c", "qca,qca9557"; + model = "devolo WiFi pro 1750c"; + + aliases { + led-boot = &status_blue; + led-failsafe = &status_red; + led-running = &status_blue; + led-upgrade = &status_red; + }; + + leds { + compatible = "gpio-leds"; + + status_blue: status_blue { + label = "dvl1750c:blue:status"; + gpios = <&gpio 14 GPIO_ACTIVE_LOW>; + default-state = "on"; + }; + + status_red: status_red { + label = "dvl1750c:red:status"; + gpios = <&gpio 15 GPIO_ACTIVE_LOW>; + }; + + buzzer { + label = "dvl1750c:gpio:buzzer"; + gpios = <&gpio 21 GPIO_ACTIVE_HIGH>; + }; + }; +}; + +&gmac_config { + rxdv-delay = <3>; + rxd-delay = <3>; + txen-delay = <3>; + txd-delay = <3>; +}; diff --git a/target/linux/ath79/dts/qca9558_devolo_dvl1xxx.dtsi b/target/linux/ath79/dts/qca9558_devolo_dvl1xxx.dtsi index 17c0a3135d..25f0ed56df 100644 --- a/target/linux/ath79/dts/qca9558_devolo_dvl1xxx.dtsi +++ b/target/linux/ath79/dts/qca9558_devolo_dvl1xxx.dtsi @@ -120,7 +120,7 @@ pll-data = <0xae000000 0x80000101 0x80001313>; - gmac-config { + gmac_config: gmac-config { device = <&gmac>; rxdv-delay = <3>; diff --git a/target/linux/ath79/image/generic.mk b/target/linux/ath79/image/generic.mk index 17f55d120c..dafb92773f 100644 --- a/target/linux/ath79/image/generic.mk +++ b/target/linux/ath79/image/generic.mk @@ -136,6 +136,14 @@ define Device/devolo_dvl1200e endef TARGET_DEVICES += devolo_dvl1200e +define Device/devolo_dvl1750c + ATH_SOC := qca9558 + DEVICE_TITLE := devolo WiFi pro 1750c + DEVICE_PACKAGES := kmod-ath10k-ct ath10k-firmware-qca988x-ct + IMAGE_SIZE := 15936k +endef +TARGET_DEVICES += devolo_dvl1750c + define Device/dlink_dir-825-b1 ATH_SOC := ar7161 DEVICE_TITLE := D-LINK DIR-825 B1 -- 2.20.0 _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/mailman/listinfo/openwrt-devel