Dear All,
When I edit foopprints' names in schematic in spreadsheet view all names
like 0805, 0603 and etc. are loosing first 0. So synchronizer can find
footprint 805.
Can somebody help me to stop changing the cell by spreadsheet editor?
Best regards,
Yuri V.Potapoff
technical expert
Rodnik
From Excel2000 help file:
Display leading or trailing zeros in a number
You can use custom number formats to retain leading zeros in numbers that
you enter.
Select the cells you want to format.
On the Format menu, click Cells, and then click the Number tab.
In the Category list, click
One caveat on the use of curved corners:- they're placed as arcs rather than
curved tracks, so if you use the autorouter it will ignore their locked
attribute (if set) and mess up your careful hand routing! (BTDT...)
Regards
Andy Gulliver
-Original Message-
From: Thomas
Assuming you're using 99SE, then you can set up a net class for each group
of nets with a particular width requirement and specify a width rule based
on net class for each class. This is one rule the autorouter actually
follows!
Regards
Andy Gulliver
-Original Message-
From: Mark W.
After re-reading your original email, I might have missed the point - if you
want different widths on different parts of the same net then you'll have to
route those segments manually as the autorouter ignores rules set by
from-to, as mentioned in an earlier reply.
Regards
Andy Gulliver
By the way this server also works with Protel 98
if anyone like me is still using it.
Darren Moore
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
Hello All,
Has anyone installed MDAC 2.6? It stated that it does not come with JET
components. There is a procedure to install JET 4.0 SP3. Doesn't Protell
99 SE require JET components to run? Has anyone done this?
Any information that you can give me will be greatly
I would actually prefer using curved traces, unfortunately the simulation
software (Ansoft) used by the RF engineer does not like curved transmission
lines. Thus, I am forced to use straight sections and 90 degree bends with
miters when doing RF designs. The RF engineer performs a full EM
Of course we can route the board by hand. I was just trying
to figure out if we could do it faster.
Best regards
mark
DUTTON Phil wrote:
Hello Mark,
I understand your problem. You can assign a width to a net with the 'Design
Rules'.
To be able to pick out a particular connection within
[EMAIL PROTECTED] wrote:
Dear All,
When I edit foopprints' names in schematic in spreadsheet view all names
like 0805, 0603 and etc. are loosing first 0. So synchronizer can find
footprint 805.
Can somebody help me to stop changing the cell by spreadsheet editor?
I don't use the Protel
Dear All,
I am trying to assist my friendly local contract manufacture, who receives
mostly Protel designs to build on his Yamaha SMD machines.
These machines are very painful to program verify.
I used to work for a company that wrote a program that graphically displayed
the placement file
11 matches
Mail list logo
