Hi Steve,
Here is the address:
http://www.protel.com/etech/learningguides.htm
Best regards,
Max
-Original Message-
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
Sent: Thursday, December 13, 2001 8:40 AM
To: Protel EDA Forum
Subject: Re: [PEDA] Fwd: Protel 99 SE Training Manual
Hi Mike,
Look at page 7 of 14 in the document pointed to by the following address.
It will show you the pin out.
http://catalog.tycoelectronics.com/TE/docs/pdf/7/95/158597.pdf
Best regards,
Max P. Henzi, CEO
Lavenir Technology
2440 Estand Way
Pleasant Hill, CA 94523
voice: (925) 680-7400
From my standpoint, it is counterproductive to start a new list to deal with
this issue. Having multiple lists merely serves to fragment the user
community. If the topic is germane to Protel users, then it should appear
on this list. I for one, do not have the time or the inclination to
Hello Burt,
I'm sorry to hear about your problems. I use Protel 99SE in conjunction
with our Lavenir software on a routine basis and to date, I have not
experienced any problems. Admittedly, I use our CAMMaster software and not
ViewMate, but the core engine for both products is similar. I run
Hi Terry,
You raise a lot of good questions. I don't think any of them can be
answered just yes or no. My opinion, as the CEO of Lavenir is not so
relevant. However, I think it would be worthwhile to give PCB manufacturers
an opportunity to weigh in on this topic, since it is so very