I'm working on a layout with two quad flat packs. A
substantial number of pins on each chip have no
connection. Because of the difficulty of
hand-soldering to fine pitch pins, I would like to add
a track and a via to each unused pin for possible use
later.
I'm have two issues:
1. DRC flags
Message-
From: Embedded Matt [mailto:[EMAIL PROTECTED]]
Sent: Thursday, May 23, 2002 2:10 PM
To: Protel EDA Forum
Subject: [PEDA] Adding extra tracks and vias.
I'm working on a layout with two quad flat packs. A
substantial number of pins on each chip have no
connection. Because
) 292-9010
email: [EMAIL PROTECTED]
http://www.norsat.com
Visit us at Booth 2G2-09 at CommunicAsia 2002 in Singapore June 18-21.
-Original Message-
From: Embedded Matt [mailto:[EMAIL PROTECTED]]
Sent: Thursday, May 23, 2002 11:10 AM
To: Protel EDA Forum
Subject: [PEDA] Adding extra
Another solution, besides those already given, is to use, in the footprint,
through pads the size of vias and with the same hole size, given the same
net as the SM pad. You will have complete DRC protection
Another solution which might be better in some ways is to add a test point
(single
I have a special schematic component : a single pin connector.
On the pcb component side I have two footprints to choose from :
1) a single pad, topside only, rectangular, no hole,
50x100 mil - great to solder a wire
2) a single pad, multilayer, round 32/62mil
great for the scope probe to