Is it possible in 99SE to have a round pad with a
10 mil gap through the center to create a jumper
that you solder when a connection is required?
I know that the Lomax Virtual Short is similar
but we want a single pad (or two halves of a pad)
instead of two separate pads.
Thanks,
Steve Smith
Michael
I'm wondering if you ever tried adding solder paste over the two pads to be
shorted by default. I didn't do it either, but would be interested in any
experience with such a technique.
Emanuel
Watnoski, Michael wrote:
adding wires. If you need the pads normally shorted, add a thin
that
these jumpers form during reflow.
Dave Eloranta
Locus Inc.
Madison, WI
-Original Message-
From: Emanuel Zimmermann [mailto:[EMAIL PROTECTED]]
Sent: Thursday, September 05, 2002 8:54 AM
To: Protel EDA Forum
Subject:Re: [PEDA] Solder jumper
Michael
I'm wondering if you ever tried
At 09:02 AM 9/5/2002 -0400, Steve Smith wrote:
Is it possible in 99SE to have a round pad with a
10 mil gap through the center to create a jumper
that you solder when a connection is required?
I know that the Lomax Virtual Short is similar
but we want a single pad (or two halves of a pad)
instead
Thanks to you all for your help.
From: Dave Eloranta
The first versions I made used Cu arcs and traces to form
2 half moons with a 6 mil gap. These worked ok until a
version change in protel and then editing the footprint
primitives to the correct net became easier if the shape
is all
? I can't think of another way.
Igor
-Original Message-
From: Steve Smith [mailto:[EMAIL PROTECTED]]
Sent: Thursday, 5 September 2002 11:03 PM
To: 'Protel EDA Forum'
Subject: [PEDA] Solder jumper
Is it possible in 99SE to have a round pad with a
10 mil gap through the center to create
though.
At least you would eliminate the board shop's confusion of the larger pad
hole that is not-to-be drilled.
- Original Message -
From: Igor Gmitrovic [EMAIL PROTECTED]
To: Protel EDA Forum [EMAIL PROTECTED]
Sent: Thursday, September 05, 2002 6:26 PM
Subject: Re: [PEDA] Solder jumper
