- Original Message -
From: Saddle [EMAIL PROTECTED]
To: Protel EDA Forum [EMAIL PROTECTED]
Sent: Sunday, July 29, 2001 6:37 PM
Subject: Re: [PEDA] Duplicating pieces of a layout
But what about if you just want to add the same design a couple of times
to
a PCB Panel. IS there a way to turn
: Monday, July 30, 2001 10:48 AM
To: Protel EDA Forum
Subject: Re: [PEDA] Duplicating pieces of a layout
I just copied a PCB, and used Paste Special and checked Keep
Net Name and
Duplicate Designator.
I could see nowhere that this would cause an error on the PCB
due to using
the same
management electronics for OEMs
http://www.PowerStream.com
- Original Message -
From: Tim Hutcheson [EMAIL PROTECTED]
To: Protel EDA Forum [EMAIL PROTECTED]
Sent: Friday, July 27, 2001 10:55 AM
Subject: Re: [PEDA] Duplicating pieces of a layout
Thanks Colby. I'll try to follow that through
Well, here is what I thought of
Rather than pasting it into ths same PCB file create a copy of the PCB file
and open the new copy. And paste your corresponding section into a new
schematic as you did... but leave it out of the hierarchy for the first part
of this.
Close the original
Thanks Colby. I'll try to follow that through as time goes by today. Right
now, I'm testing all that I can about multi-sheet and in particular the
complex hierarchy method described in my manual. But not having any luck
so far as the Create Netlist method doesn't seem to create the second cpu
- Original Message -
From: Tim Hutcheson [EMAIL PROTECTED]
To: Protel EDA Forum [EMAIL PROTECTED]
Sent: Friday, July 27, 2001 10:55 AM
Subject: Re: [PEDA] Duplicating pieces of a layout
Thanks Colby. I'll try to follow that through as time goes by today.
Right
now, I'm testing all
Cognition
40 S. Alcaniz St.
Pensacola, FL 32503
[EMAIL PROTECTED]
ICQ# 32491889
-Original Message-
From: Colby - PowerStream [mailto:[EMAIL PROTECTED]]
Sent: Friday, July 27, 2001 11:57 AM
To: Protel EDA Forum
Subject: Re: [PEDA] Duplicating pieces of a layout
I am not sure
PM
To: Protel EDA Forum
Subject: Re: [PEDA] Duplicating pieces of a layout
Exactly =)
In the article I pointed to one of the final lines is.
You must then annotate the design to ensure that all designators are
unique
Basically what this document tells you is how to copy the schematics, change
for OEMs
http://www.PowerStream.com
- Original Message -
From: Tim Hutcheson [EMAIL PROTECTED]
To: Protel EDA Forum [EMAIL PROTECTED]
Sent: Friday, July 27, 2001 12:06 PM
Subject: Re: [PEDA] Duplicating pieces of a layout
So what's the point of all this complex hierarchy stuff