Hello,
I just created a one pin schematic part. Called a guard and connected the
pin to ground in the schematic. The footprint for this part is just a
through hole pad. I hope the this helps.
-Original Message-
From: Robison Michael R CNIN [mailto:[EMAIL PROTECTED]]
Sent:
Miker,
I belive if you were to _first_ place your via such that it only cuts
through the ground plane and not any other copper, then the via will
automatically picks up GND as its net assignment. Now, if you start
placing your guard traces _starting from the via_ then those too would
At 09:01 AM 9/27/2002 -0500, Robison Michael R CNIN wrote:
I've drawn a schematic and now I'm attempting to interactively
route the traces to match some old artwork, but I've run into
some guard traces that I haven't got in the schematic. At
least I think they are guard traces. They have a via
Robison Michael R CNIN wrote:
Hello,
I've drawn a schematic and now I'm attempting to interactively
route the traces to match some old artwork, but I've run into
some guard traces that I haven't got in the schematic. At
least I think they are guard traces. They have a via to GND
at one