Thanks much Doug. I figured as much. I think running the PA at half power should be safe then.
Kevin K2KMB -----Original Message----- From: Doug Bade [mailto:[EMAIL PROTECTED] Sent: Wednesday, December 22, 2004 10:47 AM To: Repeater-Builder@yahoogroups.com Subject: [SPAM] - Re: [Repeater-Builder] Mastr II question - Email found in subject The main problem to watch for is heat/swr issues on the PA as it is potentially going to cook itself at full rated power with a high duty cycle... It will make full power and full sensitivity in 52/53 mhz, but I would de-rate the PA by a bit to protect it if it is going to be on a lot. I have not seen one which did not tune up on 6m just fine.. and I know of at least one which left the factory in the late 70's tuned on 6m... 52.525 as I recall on channel 2.... repeater splits in others... Doug KB8GVQ At 10:35 AM 12/22/2004, you wrote: >I may have access to a Mastr II 100watt low band base, 42-50Mhz, which >I'm looking at converting to a 6m repeater. I don't see anything >specific to the LB models on the RBTIP web site, unless I'm missing it. >This leads me to believe that other than replacing the crystals and >tuning it up, there arent any component changes needed? Can anyone >verify this? Also, is it safe to run the power out at around 50-60 watts >on these PA's without killing them? TIA to all! > >Kevin >K2KMB Yahoo! Groups Links Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/