Good morning to the group.
I have a situation where I have two repeaters and only one available
port. Has anyone tried this? If so, what method did you use, and what
were the results? I have done this in the past, but it was a long time
ago, and my memory isn't what it used to be. It seemed to
At 07:32 AM 10/18/2008, John Everson wrote:
Good morning to the group.
I have a situation where I have two repeaters and only one available
port. Has anyone tried this? If so, what method did you use, and what
were the results? I have done this in the past, but it was a long time
ago, and my
Has anybody tried to interface a Zetron Model 30 patch to a RC-210 or
any other multiple port controller?
The Model 30 resides on a mountain top connected to a cell phone.
It is only connected to one radio currently, but I want to make the
patch available to multiple radios on the site.
This is
Looking for some ideas...
I am running a GR500 with R1225 guts for a GMRS system. I would love
to add a link radio to link to a repeater in a nearby town. What is
the easiest way to do this?
I thought of using a RICK with two of my mobiles to receive my
repeater signal and then transmit it
Thanks for the reply.
Do you have a good source for that part?
Also, could I wire two of them in parallel, one on the radio heat
sink and one on the power supply sink?
Thanks,
Ben
--- In Repeater-Builder@yahoogroups.com, Eric Lemmon [EMAIL PROTECTED]
wrote:
Ben,
I believe that the best
The answer is in the quoted message below, but I'll repeat it since it
perhaps wasn't clear enough. The suggested thermal switch is available from
Digi-Key as their catalog number 317-1094-ND. The Digi-Key home page is
www.digikey.com If you type 317-1094-ND into the search box, it will
open
I got one of the MRE Direct RICK off eBay for a lower price than a full
blown RICK for getting the two CDM1550 that I have and was set up for full
cross band now. Very nice setup if I do say so, not to hard to program it in
the software CPS either. And its switch able so I can flip the toggle and
At 10/18/2008 08:56, you wrote:
At 07:32 AM 10/18/2008, John Everson wrote:
Good morning to the group.
I have a situation where I have two repeaters and only one available
port. Has anyone tried this? If so, what method did you use, and what
were the results? I have done this in the past,
--- I did a search for 9plws20 crystal radio crystal radio
schematics the latter site is very informational. If it would help you
any?In Repeater-Builder@yahoogroups.com, Glenn Little WB4UIV
[EMAIL PROTECTED] wrote:
I just bought a Wilson WS201 Mobile transceiver in the hopes of using
the
--- In Repeater-Builder@yahoogroups.com, [EMAIL PROTECTED] wrote:
At 10/18/2008 08:56, you wrote:
At 07:32 AM 10/18/2008, John Everson wrote:
Good morning to the group.
I have a situation where I have two repeaters and only one
available
port. Has anyone tried this? If so, what
10 matches
Mail list logo