At 03:38 PM 11/25/09, you wrote:
Hi Mike,
Thanks for the info.
Yes, I've cleaned it up good... I use a q-tip with
a baking soda/water combo, then wick solder on
the pad till it flows... sometimes gotta scrape a
shiny spot first. Then soldersuck the pad
clean up with wick. Then another qtip
!!!
Mike
Specialized Communications
KB5FLX
- Original Message -
From: Tim Ahrens
To: Repeater-Builder@yahoogroups.com
Sent: Tuesday, November 24, 2009 10:32 PM
Subject: RE: [Repeater-Builder] Spectra Audio Popping after Capacitor
replacement
Hi David,
Is the Hear Clear
[mailto:repeater-buil...@yahoogroups.com] On Behalf Of Tim Ahrens
Sent: Tuesday, November 24, 2009 10:32 PM
To: Repeater-Builder@yahoogroups.com
Subject: RE: [Repeater-Builder] Spectra Audio Popping after Capacitor
replacement
Hi David,
Is the Hear Clear board only on the 900 mhz spectras?
I
-Original Message-
From: Repeater-Builder@yahoogroups.com
[mailto:repeater-buil...@yahoogroups.com] On Behalf Of tahrens301
Sent: Tuesday, November 24, 2009 2:43 PM
To: Repeater-Builder@yahoogroups.com
Subject: [Repeater-Builder] Spectra Audio Popping after Capacitor replacement
Hi
Hi Mike,
Thanks for the info.
Yes, I've cleaned it up good... I use a q-tip with
a baking soda/water combo, then wick solder on
the pad till it flows... sometimes gotta scrape a
shiny spot first. Then soldersuck the pad
clean up with wick. Then another qtip with
lacquer thinner (contains
Hi Folks,
I've been working on these Spectras, and so far,
the capacitors have done the trick.
But on this last radio, the speaker pops whenever
the audio path is open (unsquelched, signal, mode
change, etc).
Just curious if there's something I've missed.
Thanks,
Tim
24, 2009 2:43 PM
To: Repeater-Builder@yahoogroups.com
Subject: [Repeater-Builder] Spectra Audio Popping after Capacitor
replacement
Hi Folks,
I've been working on these Spectras, and so far,
the capacitors have done the trick.
But on this last radio, the speaker pops whenever
the audio path
Hi David,
Is the Hear Clear board only on the 900 mhz spectras?
I was looking in my service manual, and it talks about
the board plugging into P501, but on my VHF spectras,
this plug is unpopulated..
As a side note, when I went to replace the capacitors,
I noticed that a fire ant had given it's
8 matches
Mail list logo