[Repeater-Builder] What's the point of the PL input on the RLC4?

Howdy, This may sound like a dumb question but I am stumped. On my RLC 4, I put in code 013 1 0 0 for port 1, PL low, COR low. So when my COR goes low, it keys up the transmitter, just like it should do. But how does the PL input help make this decision? If my PL input is low or high, the COR

Re: [Repeater-Builder] What's the point of the PL input on the RLC4?

Mike, You have programmed active low for both COR and PL but it sounds as though you have not used command 005 to set the receiver access mode to require both COR and PL. By default it requires only COR for the repeater to go active. In that state the PL input will simply be ignored. With

Re: [Repeater-Builder] What's the point of the PL input on the RLC4?

Without digging out my manual to confirm, I believe Paul is correct. You simply set the polarity, not the requirement for PL. Chuck WB2EDV - Original Message - From: Paul Kelley N1BUG paul.kelley.n1...@gmail.com To: Repeater-Builder@yahoogroups.com Sent: Monday, September 07, 2009

RE: [Repeater-Builder] What's the point of the PL input on the RLC4? [1 Attachment]

Chuck, Here is a document I have used for years and hope it works for you. Mike Mullarkey K7PFJ 6886 Sage Ave Firestone, Co 80504 303-954-9695 Home 303-954-9693 Home Office Fax 303-718-8052 Cellular From: Repeater-Builder@yahoogroups.com [mailto:repeater-buil...@yahoogroups.com]