>
> There's also http://www.speedtouch.co.uk/products/faq.asp?ProductID=471.
> Probably
> you want the "Driver for 8M lines".
>
>> Any ideas where the new firmware is? Do I need a new firmware extractor too?
>
> I've no idea where the "extended reach" driver went. Since I downloaded it
> with
Hi Steve,
> > There's an experimental feature which only works with speedtouch 330s or
> > better: download using isochronous urbs, rather than bulk urbs. This
> > should improve performance on high speed connections. You can turn it
> > on with enable_isoc=1. It may be worth turning on, becau
> Yes, once MODULE_UNLOAD is set MODULE_FORCE_UNLOAD is on via the
> default configuration options in 2.6.19.1. That said, looking back through
> my cvs it seems that I on earlier versions I had explicitly set it (although
> why I don't know).
>
> Should I try unsetting it?
Please do. I'm not s
Duncan Sands wrote:
NET: Unregistered protocol family 20
speedtch: Unknown symbol usbatm_usb_disconnect
speedtch: Unknown symbol usbatm_usb_probe
>>> I don't know what these unknown symbols are about.
>> Neither do I
>
> Just a thought: do you have CONFIG_MODULE_FORCE_UNLOAD
> set i
> What host controller driver are you using? uhci underwent major surgery
> during this time. Also, I understand that the 0xff problem you mentioned
> was fixed.
Fixed you say? Oh dear.
# lspci
00:00.0 Host bridge: VIA Technologies, Inc. VT82C598 [Apollo MVP3] (rev 04)
00:01.0 PCI bridge: VIA T
> >> NET: Unregistered protocol family 20
> >> speedtch: Unknown symbol usbatm_usb_disconnect
> >> speedtch: Unknown symbol usbatm_usb_probe
> >
> > I don't know what these unknown symbols are about.
>
> Neither do I
Just a thought: do you have CONFIG_MODULE_FORCE_UNLOAD
set in your kernel's .c
> > Lots changed in the kernel and the USB layer. Nothing changed in
> > the speedtouch driver between 2.6.17 and 2.6.18. There were some
> > changes for 2.6.19.
>
> Yes, I noticed. My question was really to do with the USB stuff, mainly
> because this all started when I experienced massive pac
Hi Duncan,
Thank you for replying so promptly, xmas break and all.
> please rebuild your kernel with CONFIG_USB_DEBUG=y. You may well then
> get some helpful messages.
Ah, good one! I shall do this just as soon as I can. My computers are
busy at the moment, so it will be a day or two before I c
Hi
> I wonder if you could help me with a problem I have with my kernel
> and ST330? My ST330 (V4, black) is connected to an old K6 400Mhz
> box which runs kernel 2.6.17.8 and used to run for days on end with
> a 2Mb link. Since I was upgraded 8Mb the modem has synced at maximum
> rate and works
