So i have public IP's , not Nat'd , on this box, 1.2.3, and I have
blocked an ip on both WAN AND LAN , any protocol, source and
destination, and traffic is still passing for this ip.
any help?
?xml version=1.0?
pfsense
version3.0/version
lastchange/
themenervecenter/theme
system
On Wed, Sep 22, 2010 at 5:33 PM, Chris Flugstad ch...@cascadelink.com wrote:
So i have public IP's , not Nat'd , on this box, 1.2.3, and I have blocked
an ip on both WAN AND LAN , any protocol, source and destination, and
traffic is still passing for this ip.
any help?
Traffic will never be
So what rule(s) would I add to block all traffic to this ip. I setup
traffice shaping and set this ip to a 5k up/down but its still much
higher than that
-chris
On 9/22/2010 2:39 PM, Chris Buechler wrote:
On Wed, Sep 22, 2010 at 5:33 PM, Chris Flugstadch...@cascadelink.com wrote:
So i
: Chris Flugstad [mailto:ch...@cascadelink.com]
Sent: Wednesday, September 22, 2010 4:44 PM
To: support@pfsense.com
Subject: Re: [pfSense Support] BLOCK IP or ALIAS firewall
rule not blocking traffic
So what rule(s) would I add to block all traffic to this ip.
I setup traffice shaping
[mailto:ch...@cascadelink.com]
Sent: Wednesday, September 22, 2010 4:44 PM
To: support@pfsense.com
Subject: Re: [pfSense Support] BLOCK IP or ALIAS firewall
rule not blocking traffic
So what rule(s) would I add to block all traffic to this ip.
I setup traffice shaping and set this ip to a 5k up/down
On Wed, Sep 22, 2010 at 6:28 PM, Chris Flugstad ch...@cascadelink.com wrote:
ryan,
i setup the the rules as you stated,, both options and the traffic is still
going to and from this ip address :(
not sure what to do from here. do i need to reboot the router?
No. At worst, resetting states.
wan rules
proto source port dest
port gw
block * 216.127.61.72 * *
**
lan rules
block * * *
On Wed, Sep 22, 2010 at 5:14 PM, Chris Flugstad ch...@cascadelink.com wrote:
wan rules
proto source port dest
port gw
block * 216.127.61.72 * *
* *
lan rules
block *
You are correct, the public ip is local on our LAN port.
i did try that before, and have gone back to it
I think when I thought I switched them , I just switched one and then
switched it back. didnt look like settings took place till i reset
states. i waited for about 3 minutes, and didnt
On Wed, Sep 22, 2010 at 5:30 PM, Chris Flugstad ch...@cascadelink.com wrote:
I did what i needed to do for the time being though. much appreciated.
And that, ladies and gentlemen, is what we call poaching the solution ;)
If this list ran on a points system I would get a flogging now.
db
10 matches
Mail list logo
