On 10/17/2009 11:10 PM, Mark Sims wrote:
At startup, Heather configures the Tbolt to broadcast the timing packets, GPS
status, and sat info packets every second. Also several messages are sent to
configure the user specified options and to request various status info.
When a primary
Just a quick report.
The 5370B ROM image seems to work just fine in a 5370A. At least one
GPIB sequence which would cause the original firmware to hang now seems
to work fine.
I put up a page describing how to change to the newer firmware, based
mostly upon an earlier post by Mark Sims:
mailing list -- time-nuts@febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
__ Information from ESET Smart Security, version of virus
signature database 4519 (20091018) __
The message was checked by ESET Smart
Lets see if this works.
I am new to the time-nuts user group
Just obtained a HP 5061a CS standard. Pumps down very well to 0 (Hard to
believe) But it did.
CS oven comes up to temp. But in operation no I beam current.
Noticed that the tube states -2083V multiplier. But its regulating to -1606V
can
Mike S a écrit :
Just a quick report.
The 5370B ROM image seems to work just fine in a 5370A. At least one
GPIB sequence which would cause the original firmware to hang now
seems to work fine.
I put up a page describing how to change to the newer firmware, based
mostly upon an earlier post
Mike S wrote:
Just a quick report.
The 5370B ROM image seems to work just fine in a 5370A. At least one
GPIB sequence which would cause the original firmware to hang now seems
to work fine.
I put up a page describing how to change to the newer firmware, based
mostly upon an earlier post by
At 12:28 PM 10/18/2009, Sylvain RICHARD wrote...
What exactly was fixed by using the newer firmware? Random hangs or
specific bugs?
It's not documented, AFAIK. Mine seemed to hang pretty regularly if I
tried to do a GPIB interface clear/device clear while it was in talk
mode and in the
Hi Alberto - have you seen the ESA website describing the system:
http://www.esa.int/esaNA/egnos.html
Regards,
Peter
On Fri Oct 16 16:49 , Alberto di Bene dib...@usa.net sent:
Anybody has some more info about this ?
http://tinyurl.com/yjeaodn
Alberto I2PHD
Mike S wrote:
Just a quick report.
The 5370B ROM image seems to work just fine in a 5370A. At least one
GPIB sequence which would cause the original firmware to hang now
seems to work fine.
I put up a page describing how to change to the newer firmware, based
mostly upon an earlier post by
How's the voltage across the hot-wire ionizer, and the mass spec voltage? I
assume the other meter readings are within the tolerances given in the
manual?
Hopefully it's not an open ionizer filament. I bought one tube on eBay
awhile back that had good vacuum but no ionizer continuity.
-- john,
Hello Everyone,
I have two more Brandywine GPS-4 units available with brand new
Panasonic antennas and coax kits.
Same price as last time... $400 for the GPS and $40 for the antenna kit.
As usual, shipping is always free (US only. International shipping will
be additional). I prefer
11 matches
Mail list logo