Anyone know what the minimum step is on the programmable frequency
output of this engine?
Tnx,
Mike
--
73,
Mike, N1JEZ
A closed mouth gathers no feet
___
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to
Hi,
I noticed these while wasting yet more time on ebay, and was wondering
if anyone knows anything about them.
Trimble 57963-80-D PCB
#301124758583
I'm assuming that it's a GPSDO board that the oscillator is sitting
on.
Thanks,
Angus.
___
time-nuts
In the manual they say from 10Hz to 10MHz so the step at least must be 10Hz.
On Thu, May 15, 2014 at 12:39 PM, Mike Seguin
n1...@burlingtontelecom.net wrote:
Anyone know what the minimum step is on the programmable frequency output of
this engine?
Tnx,
Mike
--
73,
Mike, N1JEZ
A closed
Hi fellow time-nuts,
I think this message is interesting. It shows that some receiver vendors
have been cheating on an important detail, ignoring the health status
and being confused as a result.
Cheers,
Magnus
Original Message
Subject: CGSIC: Known Problem With Certain
It would be good to understand which receivers are adversely affected by
this.. the USCG did not list affected vendors/devices..
In a message dated 5/15/2014 15:19:51 Pacific Daylight Time,
mag...@rubidium.dyndns.org writes:
Hi fellow time-nuts,
I think this message is interesting. It